Sylvain Munaut
e80c6d1961
design: Make the traces 40 mil wide with 12 mil GND separaton
...
This should keep a ~ 55 ohm impedance (close enough)
Signed-off-by: Sylvain Munaut <tnt@246tNt.com>
2012-05-19 22:18:29 +02:00
Sylvain Munaut
ab37213276
design: Move the outside holes closer to their optimal position
...
According to the WAG100 datasheet they should be 36.25 mm from the center
axis. Now they are 36.2 mm from the center axis which should work fine.
Signed-off-by: Sylvain Munaut <tnt@246tNt.com>
2012-05-18 16:24:20 +02:00
Sylvain Munaut
d997ffccfa
design: Major revision of the PCB to fit into enclosure
...
Signed-off-by: Sylvain Munaut <tnt@246tNt.com>
2012-05-18 15:00:41 +02:00
Sylvain Munaut
ba66fbbb40
design: Import original design as Eagle 6.x XML format
...
This is pretty much the first manufactured board. (just a couple
of solder mask fixes)
Signed-off-by: Sylvain Munaut <tnt@246tNt.com>
2012-05-18 12:55:35 +02:00
Sylvain Munaut
3dd0e5cf8e
design: Remove sch & brd because they were binaries from Eagle v5.x
...
Signed-off-by: Sylvain Munaut <tnt@246tNt.com>
2012-05-18 12:54:40 +02:00
Sylvain Munaut
20ee096fbf
design: Add gitignore for eagle backup files
...
Signed-off-by: Sylvain Munaut <tnt@246tNt.com>
2012-05-18 12:53:51 +02:00
Harald Welte
e8f86fb44d
add fischer case drawing
2012-05-17 16:18:28 +02:00
Harald Welte
1ca0e6e9ff
add datasheet of epcos filter
2012-01-11 14:27:43 +01:00
Harald Welte
a2e6060754
add more data sheets
2012-01-11 14:25:45 +01:00
Harald Welte
841720c93d
initial import of mini-amp project
2012-01-11 14:22:19 +01:00