manual: Document the factory default jumper setting
Also re-word/expand a bit on the situations in which NT mode or cross-over is needed. Change-Id: Ie726d4ca2e8605015a2f0384d2b435e1b40c1cad
This commit is contained in:
parent
ce1262fc51
commit
4d8e12413f
|
@ -44,8 +44,13 @@ up:
|
|||
The pin-out of the connectors can be swapped between TE and NT mode using
|
||||
the J4 and J5 jumper blocks on the circuit board.
|
||||
|
||||
A GSM BTS typically implements TE pin-out, while the icE1usb should then
|
||||
use NT mode pin-out if no cross-over cable is used.
|
||||
The factory default setting of the jumpers is TE-mode.
|
||||
|
||||
In case you're using the icE1usb with user-side equipment such as a GSM BTS,
|
||||
a PBX, a Router or the like which traditionally was attached to the public
|
||||
network, those devices all implement TE mode. In such situations you need
|
||||
to either switch the icE1usb to NT mode (and use straight wiring), or use
|
||||
an E1 cross-over cable.
|
||||
|
||||
.Pin-out of RJ45 E1 connectors
|
||||
[options="header"]
|
||||
|
|
Loading…
Reference in New Issue