Attached is a small patch that correct an issue with reading certain IBM
iSeries Comms traces.
Traces where data has been dropped for whatever reason now have the
packet number suffixed with an asterix "*", this causes the current
iSeries wiretap routine to report a "bad" header. The attached patch
simply scans the packet number field and removes any "* characters prior
to scanning, the fact that data may be missing is more than adequately
reported later by current wireshark packet processing.
Regards .. Martin
svn path=/trunk/; revision=23000
Check for a case where, conceivably, the on-the-wire packet length (from
the IP header) could be shorter than the captured data length (due to
Ethernet padding), and handle it by making sure the on-the-wire length
is always >= the captured data length.
svn path=/trunk/; revision=21490
The patch addresses issues with higher precision packet
timings on top end iSeries hardware and should enable the iseries wiretap to handle timings in both micro and nano seconds.
svn path=/trunk/; revision=19428
> I've attached a fix that cleans up this code, actually since my last
> update of this module the particular call in question was fairly
> redundant so I just went ahead and removed it and updated the constant
> that specifies the maximum possible line length instead.
>
> Thanks for bring this to my attention.
svn path=/trunk/; revision=17737
Following my last submitted patch I did some further investigation on the different types of iSeries Comms Traces, although the field formats are constant, things such as page throws and line spacing vary depending on the tool used to pull the trace form the iSeries spool.
This patch should better handle the different formats and more importantly exit in a graceful manner if an unknown format is encountered.
svn path=/trunk/; revision=17699
