2.5 KiB
M3UA Testtool and Testsuite
A test tool for M3UA as specified in RFC 3332, which is obsoleted by RFC 4666, and the ETSI specification ETSI TS 102 142. The tests are based on the ETSI test specification ETSI TS 102 381.
This tool uses guile and its extension guile-sctp for adding SCTP support. Please see README for installation instructions.
Installation
For downloading the tool and the tests run
git clone https://github.com/nplab/m3ua-testtool.git
cd m3ua-testtool
Then compile the runm3uatest using
cc -o runm3uatest runm3uatest.c
and install the binary. For example, you can issue on Linux
sudo cp runm3uatest /usr/bin
or do the following under FreeBSD
sudo cp runm3uatest /usr/local/bin
Finally change the line in dotguile
(define dir "/Users/tuexen/Documents/m3ua-testtool/")
to reflect the location of the m3ua-testtool directory and run
cp dotguile ~/.guile
Configuration
The test tool is configured by editing the file m3ua-param-testtool.scm. You can change
the IP-address and SCTP port numbers used by the test tool and the system under test by
modifying the entries:
(define sut-addr "127.0.0.1")
(define sut-port 0)
and
(define tester-addr "127.0.0.1")
(define tester-port m3ua-port)
Further down, you can also define point codes, routing contexts and even parameters sent in the M3UA handshake.
Usage
On Linux, SCTP support is implemented via a loadable kernel module. To load this module, run sudo modprobe sctp.
For FreeBSD and Solaris, no action is needed to use SCTP.
You can run specfic tests using the runm3uatest. For example, to run the m3ua-asp-aspsm-v-002 test, execute
runm3uatest m3ua-asp-aspsm-v-002
You can also run a selection of ASP tests by using the tcsh script
m3ua-testtool/run-some-asp-tests
or a selection of SGP tests by running the tcsh script
m3ua-testtool/run-some-sgp-tests
Please note that you must verify the verdict by double checking the message flows. This can be done by using a protocol analyzer like Wireshark.