The processing of the ASCONF chunks has changed a lot in the
spec. New items are:
1. A list of ASCONF-ACK chunks is now cached
2. The source of the packet is used in response.
3. New handling for unexpect ASCONF chunks.
Signed-off-by: Vlad Yasevich <vladislav.yasevich@hp.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
C4) Both ASCONF and ASCONF-ACK Chunks MUST NOT be sent in any SCTP
state except ESTABLISHED, SHUTDOWN-PENDING, SHUTDOWN-RECEIVED,
and SHUTDOWN-SENT.
Signed-off-by: Vlad Yasevich <vladislav.yasevich@hp.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
ADD-IP draft section 5.2 specifies that if an association can not
be found using the source and destination of the IP packet,
then, if the packet contains ASCONF chunks, the Address Parameter
TLV should be used to lookup an association.
Signed-off-by: Vlad Yasevich <vladislav.yasevich@hp.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
The ADD-IP "Set Primary IP Address" parameter is allowed in the
INIT/INIT-ACK exchange. Allow processing of this parameter during
the INIT/INIT-ACK.
Signed-off-by: Vlad Yasevich <vladislav.yasevich@hp.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
The Address Parameter in the parameter list of the ASCONF chunk
may be a wildcard address. In this case special processing
is required. For the 'add' case, the source IP of the packet is
added. In the 'del' case, all addresses except the source IP
of packet are removed. In the "mark primary" case, the source
address is marked as primary.
Signed-off-by: Vlad Yasevich <vladislav.yasevich@hp.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Now that we support AUTH, discard unauthenticated ASCONF and ASCONF ACK
chunks as mandated in the ADD-IP spec.
Signed-off-by: Vlad Yasevich <vladislav.yasevich@hp.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
It appears that I've managed to create two different functions both
called xfrm6_tunnel_output. This is because we have the plain tunnel
encapsulation named xfrmX_tunnel as well as the tunnel-mode encapsulation
which lives in the files xfrmX_mode_tunnel.c.
This patch renames functions from the latter to use the xfrmX_mode_tunnel
prefix to avoid name-space conflicts.
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
Signed-off-by: David S. Miller <davem@davemloft.net>
Add a new rate control algorithm based on a PID controller. It samples the
percentage of failed frames over time, feeds the result into the controller and
uses its output to control the TX rate.
Signed-off-by: Mattias Nissler <mattias.nissler@gmx.de>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Move some code out of rc80211_simple since it's probably needed for all rate
selection algorithms, and fix iwlwifi accordingly. While at it, clean up the
rate_control_get_rate() interface.
Signed-off-by: Stefano Brivio <stefano.brivio@polimi.it>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
This patch fixes should_drop_frame function to pass in ps poll control
frames required for power save functioanlity. Interface types that do not
have interest for PS POLL frames now drop it in handler.
Signed-off-by: Ron Rindjunsky <ron.rindjunsky@intel.com>
Acked-by: Johannes Berg <johannes@sipsolutions.net>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
The SNMP macros use raw_smp_processor_id() in process context
which is illegal because the process may be preempted and then
migrated to another CPU.
This patch makes it use get_cpu/put_cpu to disable preemption.
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
Signed-off-by: David S. Miller <davem@davemloft.net>
While merging the IPsec output path I moved the encapsulation output
operation to the top of the loop so that it sits outside of the locked
section. Unfortunately in doing so it now sits in front of the space
check as well which could be a fatal error.
This patch rearranges the calls so that the space check happens as
the thing on the output path.
This patch also fixes an incorrect goto should the encapsulation output
fail.
Thanks to Kazunori MIYAZAWA for finding this bug.
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
Signed-off-by: David S. Miller <davem@davemloft.net>
The NETFILTER_ADVANCED option hides lots of the rather obscure netfilter
options when disabled and provides defaults (M) that should allow to
run a distribution firewall without further thinking.
Defaults to 'y' to avoid breaking current configurations.
Signed-off-by: Patrick McHardy <kaber@trash.net>
Signed-off-by: David S. Miller <davem@davemloft.net>
Apply Eric Dumazet's jhash optimizations where applicable. Quoting Eric:
Thanks to jhash, hash value uses full 32 bits. Instead of returning
hash % size (implying a divide) we return the high 32 bits of the
(hash * size) that will give results between [0 and size-1] and same
hash distribution.
On most cpus, a multiply is less expensive than a divide, by an order
of magnitude.
Signed-off-by: Patrick McHardy <kaber@trash.net>
Signed-off-by: David S. Miller <davem@davemloft.net>
This patch generalizes the (CONFIG_IP6_NF_IPTABLES || CONFIG_IP6_NF_IPTABLES_MODULE)
test done in hashlimit_init_dst() to all the xt_hashlimit module.
This permits a size reduction of "struct dsthash_dst". This saves memory and
cpu for IPV4 only hosts.
Signed-off-by: Eric Dumazet <dada1@cosmosbay.com>
Signed-off-by: Patrick McHardy <kaber@trash.net>
Signed-off-by: David S. Miller <davem@davemloft.net>
1) Using jhash2() instead of jhash() is a litle bit faster if applicable.
2) Thanks to jhash, hash value uses full 32 bits.
Instead of returning hash % size (implying a divide)
we return the high 32 bits of the (hash * size) that will
give results between [0 and size-1] and same hash distribution.
On most cpus, a multiply is less expensive than a divide, by an order
of magnitude.
Signed-off-by: Eric Dumazet <dada1@cosmosbay.com>
Signed-off-by: Patrick McHardy <kaber@trash.net>
Signed-off-by: David S. Miller <davem@davemloft.net>
Signed-off-by: Jan Engelhardt <jengelh@computergmbh.de>
Signed-off-by: Patrick McHardy <kaber@trash.net>
Signed-off-by: David S. Miller <davem@davemloft.net>
Parenthesize macro parameters.
Signed-off-by: Jan Engelhardt <jengelh@computergmbh.de>
Signed-off-by: Patrick McHardy <kaber@trash.net>
Signed-off-by: David S. Miller <davem@davemloft.net>
A few netfilter modules provide their own union of IPv4 and IPv6
address storage. Will unify that in this patch series.
(1/4): Rename union nf_conntrack_address to union nf_inet_addr and
move it to x_tables.h.
Signed-off-by: Jan Engelhardt <jengelh@computergmbh.de>
Signed-off-by: Patrick McHardy <kaber@trash.net>
Signed-off-by: David S. Miller <davem@davemloft.net>
Use %u format specifiers as ->family is unsigned.
Signed-off-by: Jan Engelhardt <jengelh@computergmbh.de>
Signed-off-by: Patrick McHardy <kaber@trash.net>
Signed-off-by: David S. Miller <davem@davemloft.net>
We need to use rcu_assign_pointer/rcu_dereference to avoid races.
Also remove an obsolete CONFIG_IP_NAT_NEEDED ifdef.
Signed-off-by: Patrick McHardy <kaber@trash.net>
Signed-off-by: David S. Miller <davem@davemloft.net>
Similar to Maciej Soltysiak's ipt_LOG patch, include GID in addition
to UID in netlink message.
Signed-off-by: Patrick McHardy <kaber@trash.net>
Signed-off-by: David S. Miller <davem@davemloft.net>
Currently we return EINVAL for "instance exists", "allocation failed" and
"module unloaded below us", which is completely inapproriate.
Signed-off-by: Patrick McHardy <kaber@trash.net>
Signed-off-by: David S. Miller <davem@davemloft.net>
Similar to the nfnetlink_queue fixes:
The peer_pid must be checked in all cases when a logging instance exists,
additionally we must check whether an instance exists before attempting
to configure it to avoid NULL ptr dereferences.
Signed-off-by: Patrick McHardy <kaber@trash.net>
Signed-off-by: David S. Miller <davem@davemloft.net>
Whatever that comment tries to say, I don't get it and it looks like
a leftover from the time when RCU wasn't used properly.
Signed-off-by: Patrick McHardy <kaber@trash.net>
Signed-off-by: David S. Miller <davem@davemloft.net>
nf_nat_setup_info gets the hook number and translates that to the
manip type to perform. This is a relict from the time when one
manip per hook could exist, the exact hook number doesn't matter
anymore, its converted to the manip type. Most callers already
know what kind of NAT they want to perform, so pass the maniptype
in directly.
Signed-off-by: Patrick McHardy <kaber@trash.net>
Signed-off-by: David S. Miller <davem@davemloft.net>
When the timer is late its timeout might be before the current time,
in which case a very large value is dumped.
Signed-off-by: Patrick McHardy <kaber@trash.net>
Signed-off-by: David S. Miller <davem@davemloft.net>
This patch adds support for SCTP to ctnetlink.
Signed-off-by: Pablo Neira Ayuso <pablo@netfilter.org>
Signed-off-by: Patrick McHardy <kaber@trash.net>
Signed-off-by: David S. Miller <davem@davemloft.net>
This patch adds support for James Morris' connsecmark.
Signed-off-by: Pablo Neira Ayuso <pablo@netfilter.org>
Signed-off-by: Patrick McHardy <kaber@trash.net>
Signed-off-by: David S. Miller <davem@davemloft.net>
This patch adds support for master tuple event notification and
dumping. Conntrackd needs this information to recover related
connections appropriately.
Signed-off-by: Pablo Neira Ayuso <pablo@netfilter.org>
Signed-off-by: Patrick McHardy <kaber@trash.net>
Signed-off-by: David S. Miller <davem@davemloft.net>
The combination of NAT and helpers may produce TCP sequence adjustments.
In failover setups, this information needs to be replicated in order to
achieve a successful recovery of mangled, related connections. This patch is
particularly useful for conntrackd, see:
http://people.netfilter.org/pablo/conntrack-tools/
Signed-off-by: Pablo Neira Ayuso <pablo@netfilter.org>
Signed-off-by: Patrick McHardy <kaber@trash.net>
Signed-off-by: David S. Miller <davem@davemloft.net>
When terminating DSL connections for an assortment of random customers, I've
found it necessary to use iptables to clamp the MSS used for connections to
work around the various ICMP blackholes in the greater net. Unfortunately,
the current behaviour in Linux is imperfect and actually make things worse,
so I'm proposing the following: increasing the MSS in a packet can never be
a good thing, so make --set-mss only lower the MSS in a packet.
Yes, I am aware of --clamp-mss-to-pmtu, but it doesn't work for outgoing
connections from clients (ie web traffic), as it only looks at the PMTU on
the destination route, not the source of the packet (the DSL interfaces in
question have a 1442 byte MTU while the destination ethernet interface is
1500 -- there are problematic hosts which use a 1300 byte MTU). Reworking
that is probably a good idea at some point, but it's more work than this is.
Signed-off-by: Benjamin LaHaise <bcrl@kvack.org>
Signed-off-by: Patrick McHardy <kaber@trash.net>
Signed-off-by: David S. Miller <davem@davemloft.net>
Resync get_entries() with ip_tables.c by moving the checks from the
setsockopt handler to the function itself.
Signed-off-by: Patrick McHardy <kaber@trash.net>
Signed-off-by: David S. Miller <davem@davemloft.net>
Vlad Yasevich
Patrick McHardy