Command line help shows how many digits and what prefixes can be dialed.
Giving a station ID via command line will be checked for being valid.
The number to call the mobile statione will be checked for being valid.
Prefixes that are defined for a nework will be removed from station ID
automatically.
Multiple station ID lengths are supported:
* C-Netz: 7 or 8 digits, depending on area code length
* A-Netz: 5 or 7 digits; number is truncated to last 5 digits.
* IMTS/MTS: 5 or 7 digits, depending on phone's selector switch.
Use -S <dB> for setting RF level or use -S auto for auto level.
When squelch closes, audio is muted. If squelch is closed for some
seconds (depending on network), call is released. (RF loss condition)
The previous loss detection has been removed
Sound instance is now called audio instance and uses funcation pointers.
This gives a clean interface to be exchanged with other technologies,
linke SDR.
If paging tones are played in sequence, only one tone out of four tones
is played at once. The phase of all tones are calculated as if each tone
would have been sent permanently.
Connect to the oscillator of the transmitter - good girl!
You need to enable pre emphasis in this case.
Connect to the discriminator of the receiver - good boy!
You need to enable de emphasis in this case.
-W <file.wav> writes a wave file of received audio
-R <file.wav> reads a wave file to feed into decoder
This way you can record a phone and later debug without a phone
and radio equipment.