Fixes in C-Netz "magnetic" card comments.
This commit is contained in:
parent
d3a5d5c3c6
commit
b51c9f26d1
|
@ -26,8 +26,9 @@
|
|||
|
||||
/* Use a clock speed of 8 MHz. If you change it, also change the fuses!!!!
|
||||
* The CLKPS bits are set to 0 by software, so that 8 MHz clock is not divided.
|
||||
*
|
||||
* Press switch 1 to emulate card, press switch 2 to emulate BSA44 service card.
|
||||
*/
|
||||
|
||||
/* Press switch 1 to emulate card, press switch 2 to emulate BSA44 service card.
|
||||
* The LED will do short flashs, to indicate that power is on.
|
||||
*
|
||||
* Hold a switch while powering on, to enter test mode. The LED will light up.
|
||||
|
@ -38,11 +39,11 @@
|
|||
*
|
||||
* To enter programming mode, press both buttons simultaniously.
|
||||
* The LED will continously blink, to indicate programming mode.
|
||||
* Press switch 1 to select subscriber number or switch 1 to select security code.
|
||||
* Press switch 1 to change subscriber number or switch 2 to change security code.
|
||||
* The LED will then show the digit values by blinking. It can be aborted with any switch.
|
||||
* After short blinking, a long blink shows that the first digit can be entered.
|
||||
* Press switch 1 1-10 times to enter the digit. When done, press switch 2 and continue
|
||||
* with the next digit. When all digits are entered, press switch 2 again.
|
||||
* with the next digit. When all digits are entered, press switch 2 twice to confirm.
|
||||
* A soft flash of the LED (fading in and out) will indicate that the new digits are stored.
|
||||
* A false input will abort the programming procedure and restart with continuous blinking.
|
||||
* To abort programming mode, press both buttuns simultaniously.
|
||||
|
|
Loading…
Reference in New Issue