Currently single LLC blocks are discarded when the PDU lifetime
expires. If an IP packet has been fragmented either on the IP or on
the LLC layer and is therefore distributed over several LLC frames,
the kept fragments are transmitted and then discarded by the MS
because of the missing PDU. This can cause massive IP packet loss
when there are many fragmented packets (e.g. when trying 'ping
-s1800' or if the GGSN chops downlink IP packets into several SNDCP
packets).
On the other hand, discarding too many packets might disturb the
congestion handling of TCP. Dropping plain TCP ACKs might also hinder
flow control and congestion avoidance.
This commit adds a hysteresis algorithm to the LLC discard loop. If
an LLC message's age reaches the high water mark, further message's
with an age above the low water mark are discarded, too. This is
aborted, if a GMM, a non-UI, or a small message is detected. In
these cases, that message is kept.
The following VTY commands are added (pcu config node):
- queue hysteresis <1-65535> set the difference between high
(lifetime) and low watermark in
centiseconds
- no queue hysteresis disable this feature (default)
Since the SGSN will most probably send all fragments of a single
N-PDU without much delay between them, a value slightly above the
average transmission delay jitter between SGSN and PCU is probably a
sensible value to discard all fragments of a single IP packet.
This is an experimental feature that might be replaced by more
advanced means of active queue management in the future.
Sponsored-by: On-Waves ehf
Currently a DL TBF is immediately closed, when the LLC queue is
drained. This will lead to a new DL assignment if data is received
afterwards. In addition, it is not possible to keep the PACCH open
to poll the MS for UL establishment requests there.
GSM 44.060, 9.3.1a suggests to delay the release of an inactive TBF
for some time (max 5s).
This commit mainly changes create_new_bsn() to send LLC dummy
commands as filler if no LLC data is available until keep_open()
returns false. The keep_open() functions returns true unless a
configurable time has passed after the LLC data store drained. By
default, that time is not set which causes keep_open() to always
return false, so that delayed release is effectively disabled.
The following VTY commands are added:
- dl-tbf-idle-time <1-5000> to set the delay in ms
- no dl-tbf-idle-time to disable delayed release
Ticket: #556
Sponsored-by: On-Waves ehf
Jacob Erlbeck