So far, we only started the ALIVE procedure on RESET-ACK if the
remote end was the SGSN. This resulted in the BSS->Proxy connections
only being tested for alive-status from the BSS side, but not from
our side.
Also: export nsvc_by_nsvci() function as a public API function.
Some BSS that connect to the proxy do not continue to perform the
RESET procedure after a timeout. In order to resurrect them, we
simply start a RESET procedure.
In the previous code we used a static fake_nsvc structure in
case we needed to send a message to an unknown NSVC for which
we don't have a real 'struct nsvc'. However, since we now have
a rate_ctr_group hanging off the nsvc, the fake structure didn't
have that.
So now we keep a nsi->unknown_nsvc around to be used whenever
we need a nsvc but don't have a real one. The gprs_ns_vty.c
code explicitly does not list that NSVC in 'show ns'
Every NS-VC now has a set of counters for incoming and outgoing
number of packets and bytes.
We also split the VTY part of the gprs_ns.c implementation into gprs_ns_vty.c
to make sure the protocol can actually be used without the VTY code being
present.
As only NS-UNITDATA messages are ever passed into the Gb Proxy,
we need to do the msgb_free() at a much higher point in the calling
stack, i.e. inside the NS protocol layer. This means it is now
the same logic as in OpenBSC itself.
With persistent NS-VC configuration (configured through VTY),
we can respond properly to BSS with a somewhat strange NS
implementation Such as the BSplus. It enables us to respond
with a proper NS-RESET (including NSVCI/NSEI) when receiving
a NS-ALIVE or other PDU for a BLOCKED/DEAD NS-VC after our
end of the connection is rebooted.
Harald Welte