osmo-msc/include/openbsc/mncc_int.h

#ifndef _MNCC_INT_H
#define _MNCC_INT_H

#include <stdint.h>

struct mncc_int {
	uint8_t def_codec[2];
};

extern struct mncc_int mncc_int;

uint8_t mncc_codec_for_mode(int lchan_type);

#endif
Add VTY command to specify default speech codec In order to have the MNCC application reliably decide on the codec type, it needs to know if we are running on a TCH/F or TCH/H. Thus, we pass lchan_mode as a new parameter to the 'struct gsm_mncc' 2011-09-01 16:18:43 +00:00			`#ifndef _MNCC_INT_H`
			`#define _MNCC_INT_H`

			`#include <stdint.h>`

			`struct mncc_int {`
			`uint8_t def_codec[2];`
			`};`

			`extern struct mncc_int mncc_int;`

mncc: Use the default codec from the built-in mncc mode In case of the RTP bridge mode we need to select the codec ourselves. Rely on the same (incomplete) codec selection that can be done using the mncc-int configuration node. This might gain bearer capabilities support. In case of a SDCCH a TCH/F will be attempted to be assigned. This is an open issue for both modes and there should be a preference for full or half-rate channels somewhere. 2015-08-20 17:10:58 +00:00			`uint8_t mncc_codec_for_mode(int lchan_type);`

Add VTY command to specify default speech codec In order to have the MNCC application reliably decide on the codec type, it needs to know if we are running on a TCH/F or TCH/H. Thus, we pass lchan_mode as a new parameter to the 'struct gsm_mncc' 2011-09-01 16:18:43 +00:00			`#endif`