In bts_model_l1sap_down() we want to identify BCCH/CCCH channel numbers,
but our check is a bit non-specific. Let's make the check more specific
to only cover the BCCH, Uplink CCCH and Downlink CCCH C-bits as defined
n 3GPP TS 08.58 Section 9.3.1
Change-Id: Ia20ab09b96c87c0dfbfaf98e5b2a8d36423fac67
In a larger simulated network with multiple BTSs it is normal that one
BTS will see GSMTAP frames for an ARFCN that is not an ARFCN used by the
local BTS. This is just normal operation.
Change-Id: Ic68cace9648ccb17500c94b6ede8814674aa9c29
It is important that we reliably terminate the BTS in case any of the
VirtPHY multicast sockets dies for whatever reason.
Change-Id: I5ae3fdd7cc35fdf235550a3b8362020fdd287c13
The defaults must be set during bts_model_phy_link_set_defaults()
and can then later be overridden by the vty (from the config file).
They should only be written back to the file if they differ from
the default settings.
Change-Id: I5d7f2c1dc8bc3d11db5c607b664730e4dcd58c96
This patch adds a virtual physical layer designed to simulate the
Um air interface between BTS and MS. It does so by encapsulating MAC
blocks (Layer 2 PDUs) via GSMTAP and sending them through multicast UDP
streams, both in uplink and in downlink.
The purpose of this is enable testing without any radio hardware or
related licenses.
OsmocomBB has recently received as similar patch-set, adding a virty_phy
executable that can be run on a PC instead of the classic 'layer1'
firmware on a real phone.
Using GSMTAP means that one can use unmodified wireshark to decode the
messages exchanged on the virtual Um layer.
This code was originally started by Harald in January 2016, continued
by Sebastian Stumpf in late 2016 and early 2017, and finally completed
by Harald in July 2017.
Change-Id: I1bf7670975b1e367c1c62983020865a043542622
Harald Welte