Fix two bugs in OML software download code where we allocate data structures
using talloc, but free() them using the system memory allocator. Spotted by
dexter.
Each BTS gets its own E1 line data structure. They are meant to bind
each to their own (virtual?) mISDN device.
BTS0 uses TS01 (siganlling) and TS02/03 (TRX0), TS04/05(TRX1)
BTS1 uses TS11 (siganlling) and TS12/13 (TRX0), TS14/15(TRX1)
BTS2 uses TS21 (siganlling) and TS22/23 (TRX0), TS24/25(TRX1)
In order to use multiple mISDN cards, we need to:
1) move driver initialization out of line initialization
2) make sure we allow partial (virtual) E1 cards with < 30 B-channels
* remove old HAVE_TRX1 definition, replace it with '-1' commandline argument
* make sure we actually configure the OML TRX attributes with a different
ARFCN than TRX0
* make sure we configure timeslot 0 of TRX1 also in TCH/F mode
This code is untested, but if you have a dual-trx BS-11, and the second TRX
is activated, you should be able to run bsc_hack with the -1 option to enable
and use the second trx. It works like this:
* TRX1 shares E1 timeslot 0 for signalling
* TRX1 RSL link uses TEI2 (TRX0 uses 1)
* TRX1 on ARFCN+2, i.e. if you have TRX0 on 122, TRX1 will be 124
* we only need one piece of code to calculate rsl_ie_chan_mode from
our run-time data structures (gsm_lchan)
* add some more channel modes for TCH/H and data
* use enum's to make the compiler warn us about unhandled enum values
* make sure the caller determines the (signalling,speech,data) mode
only after the LCHAN_MODIFY we know the final mode of the channel,
so we have to postpone our IPAC_BIND until then to make sure we set
the correct speech codec.
* explicitly set the "ip speech mode" IE during BIND and CONNECT messages,
depending on the speech codec used by the voice call
* more verbose debug messages regarding IPAC_BIND and IPAC_CONNECT
* do not always blindly specify RTP payload type, but use the value
returned by BIND_ACK, _if_ it is present.
Up until now, we only supported direct RTP streams between ip.access BTS.
With this commit, the user can specify '-P' to the command line to enable
a RTP/RTCP proxy inside OpenBSC. The nanoBTS will then send all their voice
data to OpenBSC, which will relay it to the respective destination BTS (which
can be the same BTS).
The default behaviour remains unchanged. Without '-P' on the command line,
RTP/RTCP is exchanged directly.
* explicitly set the "ip speech mode" IE during BIND and CONNECT messages,
depending on the speech codec used by the voice call
* more verbose debug messages regarding IPAC_BIND and IPAC_CONNECT
* do not always blindly specify RTP payload type, but use the value
returned by BIND_ACK, _if_ it is present.
The rtp_proxy.[ch] code is intended to be used as a transparent
RTP/RTCP proxy, relaying the media streams from one ip.access BTS
to another. In an 'ideal' network, this is obviously not needed,
since the BTS's can send those streams directly between each other.
However, for debugging, 'lawful interception', transcoding or interfacing
a TRAU/E1 based BTS, we actually need to process those RTP streams
ourselves.
Harald Welte
Harald Welte