previously the card RST, VCC, and CLK signal states have been initialized with default values corresponding to an inactive reader. this worked fine for actual inactive readers since the default values match and would be updated when the signal changes (edge detection). but if the reader is in another state, card activation detection could fail. this is fixed since the actual signal values are now used during initialisation. at the same time I changed the variable type from uint8_t to boolean since they have only two possible states, and understanding the actual state when coding is simpler (no need to check which integer corresponds to which state). this change has been successfully tested on the 2 slots of OWHW board. Change-Id: Ie9245d75d48ae93d16f97897d4fa5ad6cd402e73 |
||
---|---|---|
contrib | ||
debian | ||
firmware | ||
hardware | ||
host | ||
.gitignore | ||
.gitmodules | ||
Makefile | ||
README.md | ||
clk_calc.py | ||
git-version-gen |
README.md
SIMtrace v2.0
This is the repository for the next-generation SIMtrace devices, providing abilities to trace the communication between (U)SIM card and phone, remote (U)SIM card forward, (U)SIM man-in-the-middle, and more.
This is under heavy development, and right now it is not surprising if things still break on a daily basis.
NOTE: Nothing in this repository applies to the SIMtrace v1.x hardware or its associated firmware. SIMtrace v1.x is based on a different CPU / microcontroller architecture and uses a completely different software stack and host software.
Supported Hardware
At this point, the primary development target is still the OWHW + sysmoQMOD device, but we expect to add support for a SAM3 based SIMtrace hardware board soon.
The goal is to support the following devices:
- Osmocom SIMtrace 1.x with SAM3 controller ** this is open hardware and schematics / PCB design is published
- sysmocom sysmoQMOD (with 4 Modems, 4 SIM slots and 2 SAM3) ** this is a proprietary device, publicly available from sysmocom
- sysmocom OWHW (with 2 Modems and 1 SAM3 onboard) ** this is not publicly available hardware, but still supported
This Repository
This repository contains several directory
- firmware - the firmware to run on the actual devices
- hardware - some information related to the hardware
- host - Programs to use on the USB host to interface with the hardware