The SIMtrace2 protocol alwasy contained a field for the VCC voltage,
the cardem firmware just never populated that field, even on those
boards that use the ADC to determine its voltage.
Change-Id: Idcecad553fb36380e916378e1420488acbbfa8e3
Remove the paragraph about writing to the Free Software Foundation's
mailing address. The FSF has changed addresses in the past, and may do
so again. In 2021 this is not useful, let's rather have a bit less
boilerplate at the start of source files.
Change-Id: Ie0a3b2273383adbb3303faffd6ff96be7f4cae99
Instead of using the timer/counter peripheral to handle the waiting time
and corresponding timeout, the USART peripheral internal timeout
mechanism is used.
This is particularly important for the SIMtrace board since there
(contrary to other boards) the I/O signal is not wired to a TIO pin
of the timer/counter block, and hence Rx/Tx data cannot reset that
timer/counter.
As a result of this migration, cardem is now supported not only on
owhw + qmod, but also on the simtrace board.
The guts of this change have been lifted out of Change-Id
Ibcb2c8cace9137695adf5fb3de43566f7cfb93b5 by Kevin Redon, which was
unfortunately touching various different topics at the same time and
hence was split up. Some improvements are the introduction of the
ENABLE_TX_TIMER_ONLY mode, which avoids the USART interrupt handler
getting hammered with TXRDY between release of RST and start of the ATR.
Change-Id: Ibcb2c8cace9137695adf5fb3de43566f7cfb93b5
Related: OS#1704
The new SIMTRACE_MSGT_BD_CEMU_CONFIG command can be used to set/change
a bitmask of optional features that can be enabled in the simtrace
by the host software. This is useful for enabling features in the
firmware which are not supported by older host utilities.
The firmware will return the actually set/configured features in
response.
The feature bitmask is not yet used anywhere; it will be by subequent
patches.
Change-Id: I7cdd3f9171dbed45de0089defe29d2b59044bd84
previously the card RST, VCC, and CLK signal states have been initialized with
default values corresponding to an inactive reader.
this worked fine for actual inactive readers since the default values match
and would be updated when the signal changes (edge detection).
but if the reader is in another state, card activation detection could fail.
this is fixed since the actual signal values are now used during initialisation.
at the same time I changed the variable type from uint8_t to boolean since they
have only two possible states, and understanding the actual state when coding
is simpler (no need to check which integer corresponds to which state).
this change has been successfully tested on the 2 slots of OWHW board.
Change-Id: Ie9245d75d48ae93d16f97897d4fa5ad6cd402e73
this changes how ATR is handled.
the ATR is also printed when set (as important debug information).
the test is also updated to correspond to the new mechanism (
simulating the timeout before sending the ATR)
Change-Id: I69df797e2feadffa9f5f977cb71b69386cee7cd0
We now generalize the USB communiction and abandon the 'req_ctx'
structure inherited from openpcd. Instead we use the libosmocore 'msgb'
structure to handle incoming and outgoing USB tranfers. We also use
linuxlist-based msgb-queues for each endpoint.
Harald Welte
Oliver Smith
Kevin Redon