When building with -DNDEBUG, assert(0) will not stop execution
so it must not be used for abnormal termination.
Use cpu_abort() when in CPU context, abort() otherwise.
Signed-off-by: Blue Swirl <blauwirbel@gmail.com>
QEMU uses a fixed page size for the CPU TLB. If the guest uses large
pages then we effectively split these into multiple smaller pages, and
populate the corresponding TLB entries on demand.
When the guest invalidates the TLB by virtual address we must invalidate
all entries covered by the large page. However the address used to
invalidate the entry may not be present in the QEMU TLB, so we do not
know which regions to clear.
Implementing a full vaiable size TLB is hard and slow, so just keep a
simple address/mask pair to record which addresses may have been mapped by
large pages. If the guest invalidates this region then flush the
whole TLB.
Signed-off-by: Paul Brook <paul@codesourcery.com>
Removes a set of ifdefs from exec.c.
Introduce TARGET_VIRT_ADDR_SPACE_BITS for all targets other
than Alpha. This will be used for page_find_alloc, which is
supposed to be using virtual addresses in the first place.
Signed-off-by: Richard Henderson <rth@twiddle.net>
env->exception_index should be cleared with -1, not 0.
See also 821b19fe92.
Spotted by Igor Kovalenko.
Signed-off-by: Blue Swirl <blauwirbel@gmail.com>
On SH4, the ITLB and UTLB configurations are memory mapped, so loading
ITLB entries from UTLB has to be simulated correctly. For that the QEMU
TLB has to be handle the execute (ITLB) and read/write permissions
(UTLB) seperately.
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
With the current code, the QEMU TLB is setup to match the read/write
mode of the MMU fault. This means when read access is done, the page
is setup in read-only mode. When the page is later accessed in write
mode, an MMU fault happened, and the page is switch in write-only
mode. This flip-flop causes a lot of calls to the MMU code and slow
down the emulation.
This patch changes the MMU emulation, so that the QEMU TLB is setup
to match the UTLB protection key. This impressively increase the
speed of the emulation.
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
There is an ITLB access violation if SR_MD=0 (user mode) while
the high bit of the protection key is 0 (priviledge mode).
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
The mem_idx is wrongly computed. As written in target-sh4/cpu.h, mode 0
corresponds to kernel mode (SR_MD = 1), while mode 1 corresponds to user
mode (SR_MD = 0).
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
In the very least, a change like this requires discussion on the list.
The naming convention is goofy and it causes a massive merge problem. Something
like this _must_ be presented on the list first so people can provide input
and cope with it.
This reverts commit 99a0949b72.
Signed-off-by: Anthony Liguori <aliguori@us.ibm.com>
Problem: Our file sys-queue.h is a copy of the BSD file, but there are
some additions and it's not entirely compatible. Because of that, there have
been conflicts with system headers on BSD systems. Some hacks have been
introduced in the commits 15cc923584,
f40d753718,
96555a96d7 and
3990d09adf but the fixes were fragile.
Solution: Avoid the conflict entirely by renaming the functions and the
file. Revert the previous hacks.
Signed-off-by: Blue Swirl <blauwirbel@gmail.com>
handle_cpu_signal is very nearly copy-paste code for each target, with a
few minor variations. This patch sets up appropriate defaults for a
generic handle_cpu_signal and provides overrides for particular targets
that did things differently. Fixing things like the persistent (XXX:
use sigsetjmp) should now become somewhat easier.
Previous comments on this patch suggest that the "activate soft MMU for
this block" comments refer to defunct functionality. I have removed
such blocks for the appropriate targets in this patch.
Signed-off-by: Nathan Froyd <froydnj@codesourcery.com>
Signed-off-by: Anthony Liguori <aliguori@us.ibm.com>
Include assert.h from qemu-common.h and remove other direct uses.
cpu-all.h still need to include it because of the dyngen-exec.h hacks
Signed-off-by: Paul Brook <paul@codesourcery.com>
This replaces a compile time option for some targets and adds
this feature to targets which did not have a compile time option.
Add monitor command to enable or disable single step mode.
Modify monitor command "info status" to display single step mode.
Signed-off-by: Stefan Weil <weil@mail.berlios.de>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@7004 c046a42c-6fe2-441c-8c8c-71466251a162
Signed-off-by: Edgar E. Iglesias <edgar.iglesias@gmail.com>
git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@6970 c046a42c-6fe2-441c-8c8c-71466251a162
The entire U0 area is assumed to be cacheable.
Signed-off-by: Edgar E. Iglesias <edgar.iglesias@gmail.com>
git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@6969 c046a42c-6fe2-441c-8c8c-71466251a162
Author: Vladimir Prus <vladimir@codesourcery.com>
Fix movcal.l/ocbi emulation.
* target-sh4/cpu.h (memory_content): New.
(CPUSH4State): New fields movcal_backup and movcal_backup_tail.
* target-sh4/helper.h (helper_movcal)
(helper_discard_movcal_backup, helper_ocbi): New.
* target-sh4/op_helper.c (helper_movcal)
(helper_discard_movcal_backup, helper_ocbi): New.
* target-sh4/translate.c (DisasContext): New field has_movcal.
(sh4_defs): Update CVS for SH7785.
(cpu_sh4_init): Initialize env->movcal_backup_tail.
(_decode_opc): Discard movca.l-backup.
Make use of helper_movcal and helper_ocbi.
(gen_intermediate_code_internal): Initialize has_movcal to 1.
Thanks to Shin-ichiro KAWASAKI and Paul Mundt for valuable feedback.
Acked-by: Edgar E. Iglesias <edgar.iglesias@gmail.com>
git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@6966 c046a42c-6fe2-441c-8c8c-71466251a162
and process termination in legacy applications. Try to guess which we want
based on the presence of multiple threads.
Also implement locking when modifying the CPU list.
Signed-off-by: Paul Brook <paul@codesourcery.com>
git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@6735 c046a42c-6fe2-441c-8c8c-71466251a162
With my previous patch (the one monitoring tlb), I found that the last
TLB entry was never use. Here a little fix.
Signed-off-by: Lionel Landwerlin <lionel.landwerlin@openwide.fr>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@6671 c046a42c-6fe2-441c-8c8c-71466251a162
Original idea&code by Kevin Wolf, split-up in two patches and added more
archs.
This patch introduces a flag to log CPU resets. Useful for tracing
unexpected resets (such as those triggered by x86 triple faults).
Signed-off-by: Jan Kiszka <jan.kiszka@siemens.com>
Signed-off-by: Anthony Liguori <aliguori@us.ibm.com>
git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@6452 c046a42c-6fe2-441c-8c8c-71466251a162
These are references to 'loglevel' that aren't on a simple 'if (loglevel &
X) qemu_log()' statement.
Signed-off-by: Eduardo Habkost <ehabkost@redhat.com>
Signed-off-by: Anthony Liguori <aliguori@us.ibm.com>
git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@6340 c046a42c-6fe2-441c-8c8c-71466251a162
This is a large patch that changes all occurrences of logfile/loglevel
global variables to use the new qemu_log*() macros.
Signed-off-by: Eduardo Habkost <ehabkost@redhat.com>
Signed-off-by: Anthony Liguori <aliguori@us.ibm.com>
git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@6338 c046a42c-6fe2-441c-8c8c-71466251a162
The attached patch updates the FSF address in the GPL/LGPL boilerplate
in most GPL/LGPLed files, and also in COPYING.LIB.
Signed-off-by: Stuart Brady <stuart.brady@gmail.com>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@6162 c046a42c-6fe2-441c-8c8c-71466251a162
This patch removes useless type information in some calls to
tcg_temp_local_new. It also removes the parameter from the
macro declaration; if a target has to use a specific non-default
size then it should use tcg_temp_local_new_{i32,i64}.
Signed-off-by: Laurent Desnogues <laurent.desnogues@gmail.com>
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@6146 c046a42c-6fe2-441c-8c8c-71466251a162
Change from v1:
Avoid changing the existing coding style in certain files.
Signed-off-by: Stuart Brady <stuart.brady@gmail.com>
git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@6120 c046a42c-6fe2-441c-8c8c-71466251a162
Based on a patch from Lionel Landwerlin.
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@6015 c046a42c-6fe2-441c-8c8c-71466251a162
Blue Swirl