The 'verbosity' parameter may be used to increase or suppress output from
libbladeRF. The available log levels are, in order of decreasing
verbosity are:
verbose, debug, info, warning, critical, silent
The 'loopback' parameter may be used to put the bladeRF into one of the
supported loopback modes. The valid modes are listed below. Their
descriptions may be found in the libbladeRF documentation:
bb_txlpf_rxvga2, bb_txlpf_rxlpf bb_txvga1_rxvga2, bb_txvga1_rxlpf
rf_lna1, rf_lna2, rf_lna3
libbladeRF provides accessors for rational sample rates, which the
integer sample rate functions use under the hood. Therefore, there's no
need to check if the requested rate contains a fractional portion and
switch between the two sets of functions.
Common parameter handling has been moved into bladerf_common::init().
The buflen parameter is now in units of samples, not bytes. This
deviates from the other gr-osmosdr items. However, with the requirement
that buffers be in multiples of 1024 samples, this makes specifying this
parameter a bit easier. The user shouldn't need to know we're operating
on SC16Q12 values under the hood, and have to calculate accordingly.
To avoid confusion when both a bladeRF source and sink are in a flow
graph a [bladeRF source/sink] prefix has been added to output. Error
number have been replaced with bladeRF string representations of these
error values.
Firmware flashing has been removed. The bladeRF-cli or bladeRF-flash
tools are the preferred route for firmware upgrades.
The gr_complex FIFO is no longer used on the TX side, so it doesn't
really make sense to have it in bladerf_common. The associated items
have been moved into bladerf_source, and some renaming has been done in
bladerf_sink to tidy up.
Pending further performance tests of the bladerf_source, the _fifo
member (boost::circular_buffer) may need to be replaced.
This is based on the original work (https://github.com/Nuand/gr-osmosdr)
done by folks at nuand LLC for the gr3.6 branch of gr-osmosdr.
The following modifications have been done in this commit:
* port to gr-osmosdr master codebase (gr3.7)
* moved shared properties to bladerf_common
* added & verified IF filter bandwidth setters
* set LMS6002D registers with values taken from FAQ 5.27
* print device information (serial/versions) on startup
* added fpga= and fw= device arguments to program MCU/FPGA
* added bladerf=# dev. arg. to select a specific bladeRF
* grc gain field controls RF path VGA for RX/TX
* grc BB gain field controls BB path VGA for RX/TX
Usage example:
osmocom_fft -a "bladerf,fpga=/tmp/hostedx115.rbf"
The following RX named gain stages are available:
LNA: 0 to 6 dB, in 3dB steps
VGA1: 5 to 30 dB, in 1dB steps; nonlinear mapping done inside the lib
VGA2: 0 to 60 dB, in 3dB steps; not recommended to be used above 30dB
The following TX named gain stages are available:
VGA1: -35 to -4 dB, in 1dB steps, BB side
VGA2: 0 to 25 dB, in 1dB steps, RF side
Thanks a lot to the team of nuand LLC for this major contribution.
Brian Padalino
Dimitri Stolnikov