;[general]
; max_down: long: The time in seconds after a sctp socket is in connection
;  hanging state. After this time expires the connection is re-established.
; If the connection is not re established the timer will exponential back off
;  until reaches 60 seconds
;max_down=10

; Each section in this file describes a SIGTRAN connection
; Connections are referenced from other configurations describing the upper layer

;[name-of-connection]
; The name of the section identifies the connection

; type: keyword: Socket type - sctp, tcp, udp, unix
;type=sctp

; stream: bool: Socket connection type.
; Designed for SCTP sockets to create a stream socket or a sequenced packet socket
; NOTE: for M2PA if stream is false the M2PA autostart should be on true on both ends,
;  if stream is true the M2PA autostart must be true only at one end
;stream=true for TCP or UNIX sockets, false for other types

; local: string: Primary local address
; Format is ipv4:port like: 1.1.1.1:3566
;local=

; localN: string: Additional local addresses, SCTP only
; Multiple addresses can be specified by incrementing the 1-based index at the end of 'local'
; The address format is ip:port like:
;  local1=1.2.3.4:3566
;  local2=2.3.4.5:3566
;local1=

; remote: string: Primary remote address
; Format is ipv4:port like: 2.2.2.2:3566
;remote=

; remoteN: string: Additional remote addresses, SCTP only
; Multiple addresses can be specified by incrementing the 1-based index at the end of 'remote'
; The address format is ip:port like:
;  remote1=5.6.7.8:3566
;  remote2=6.7.8.9:3566
;remote1=

; endpoint: bool: Set to true if this is an endpoint that actively tries to connect,
;  false to listen for remote connections
;endpoint=false

; linger: int; How much to block waiting for socket to close.
;linger = 0

; listen-notify: boolean: True to notify the upper layer that a new incoming connection has been established
; Default to true
;listen-notify=true


; SCTP parameters
; NOTE these parameters will be set only for SCTP sockets
; Note! On some platforms this parameters may not be supported

; Set initial retransmission interval in milliseconds
; Ex: rto_initial = 400
;rto_initial=

; Set maximum retransmission interval in milliseconds
; Ex: rto_max = 800
;rto_max=

; Set minimum retransmission interval in milliseconds
; Ex: rto_min = 200
;rto_min=

; Set heartbeat interval in milliseconds
; Ex: hb_interval = 5000
;hb_interval=

; Set maximum number of retransmissions before the SCTP connection is considered down
; Ex: max_retrans = 5
;max_retrans=

; Enable / disable SCTP heartbeat. Default is enabled
; Ex: hb_enabled = true
;hb_enabled=

; Set sctp delayed ack parameters
; Note! Both sack_delay and sack_freq must be present and have values different than 0 to be successfully applied

; Set ack time interval for sccp to cumulative acknowledge the received packets
; Max value 500 in milliseconds
; Ex: sack_delay = 50
;sack_delay=

; Set the maximum number of unacknowledged packets
; Ex: sack_freq = 2
; Note! If you set this to 1 you will disable the sctp acknowledge algorithm
;sack_freq=

; Set sctp socket adaptation parameter
; E.g. : sctp_adaptation=1
;sctp_adaptation=