WANPIPE POS Support
===================


Author: Nenad Corbic <ncorbic@sangoma.com>



Pre requisites
--------------

1. A Linux kernel source must be available.
   Usually in /usr/src/linux directory.
   
   Furthermore, the linux source version must
   match the currently running image.

   i.e. Output of 'uname -r'
        must match the source version
	number in /usr/src/linux/Makefile.

   Note: The Setup installation script checks
         for this condition and will take
	 appropriate steps to resolve the
	 name mismatch.




Installing WANPIPE with POS support
-----------------------------------

The POS support is not installed by default
during WANPIPE installation process.

To enable POS support install WANPIPE using
the --protocol option:

	./Setup install --protocol=POS


Follow the Setup installation script and choose
all DEFAULT options.

After successful installation proceed to 
configure you POS card using /usr/sbin/wancfg 
GUI configurator.


Installation Verification
-------------------------

Run wanpipe hardware probe to
make sure that the kernel modules
are working fine:

Run:	wanrouter hwprobe


	In case of error:
	-----------------

	Please contact Sangoma Tech Support
	Tel. 	905 474 1990 ex118 
	Email:  techdesk@sangoma.com


Configuring POS 
---------------

Run: /usr/sbin/wancfg

1. Create new device

2. Select wanpipe1

3. Protocol Section
	Select Protocol: POS Protocol

4. Hardware Section
	Select Probe Hardware
		Select your adapter PRI port.

	Select POS Protocol
		Select desired POS protocol
		IBM,NCR,ICL ..

5. Interface Section
	Specify interface name.
	(Leave it default)

6. End of configuration, exit and save



Start POS card
--------------

Run: wanrouter start


	In case of errors:
	------------------
	Run: 	wanrouter messages
       	
		It will display kernel error
		messages.

	Please contact Sangoma Tech Support
	Tel. 	905 474 1990 ex118 
	Email:  techdesk@sangoma.com


Startup Confirmation
--------------------

Run: wanrouter messages

     Confirm that "Pos Firmware Ready!" message exist



Custom API Application
----------------------

A sample API application exists in
/etc/wanpipe/api/pos directory.

To compile it run:  make

To run it run:      ./pos_api wanpipe1 <ifname> 
		 
		    Where <ifname> is the name of
		    your interface. If you left it default
		    it would be:

		    	./pos_api wanpipe1 wp1pos

	The APP will configure the POS card
	and enable both POS sync ports for
	receiving.  

	All data received will be printed out in HEX.


Use this app as a building block for you custom
APP.


POS API Documentation
----------------------

Complete API document that includes all wanpipe
commands, is located in:

	/etc/wanpipe/api/pos/pos_api.pdf




Further Info
------------

	Please contact Sangoma Tech Support
	Tel. 	905 474 1990 ex118 
	Email:  techdesk@sangoma.com