WANPIPE ATM Support
===================


Author: Nenad Corbic <ncorbic@sangoma.com>



Pre requisites
--------------

1. A Linux kernel source must be available.
   Usually in /usr/src/linux directory.
   
   Furthermore, the linux source version must
   match the currently running image.

   i.e. Output of 'uname -r'
        must match the source version
	number in /usr/src/linux/Makefile.

   Note: The Setup installation script checks
         for this condition and will take
	 appropriate steps to resolve the
	 name mismatch.




Installing WANPIPE with ATM support
-----------------------------------

The ATM support is installed by default
during WANPIPE installation process.

	./Setup install 

Follow the Setup installation script and choose
all DEFAULT options.

After successful installation proceed to 
configure the card for ATM protocol /usr/sbin/wancfg 
GUI configurator.


Installation Verification
-------------------------

Run wanpipe hardware probe to
make sure that the kernel modules
are working fine:

Run:	wanrouter hwprobe


	In case of error:
	-----------------

	Please contact Sangoma Tech Support
	Tel. 	905 474 1990 ex118 
	Email:  techdesk@sangoma.com


Configuring ATM
---------------

Run: /usr/sbin/wancfg

1. Create new device

2. Select wanpipe1

3. Protocol Section
	Select Protocol: ATM Protocol

4. Hardware Section
	Select Probe Hardware
		Select your adapter PRI port.

5. Interface Section
	
   Select number of PVC you wish to configure
   (Default=1)
	
	Specify interface name.
	(Leave it default)
	
	Specify ATM VPI, VCI values for that pvc
	
	Specify ATM Encapsulation Headers:
		Ethernet over ATM (LLC/VC) (PPPoE)
	        Classical IP over ATM (LLC/VC)
	
	Specify IP info for pvc

6. End of configuration, exit and save



Start ATM protocol
------------------

Run: wanrouter start


	In case of errors:
	------------------
	Run: 	wanrouter messages
       	
		It will display kernel error
		messages.

	Please contact Sangoma Tech Support
	Tel. 	905 474 1990 ex118 
	Email:  techdesk@sangoma.com


Startup Confirmation
--------------------

Run: wanrouter messages

	Make sure no error messages are dispalyed.

 	Confirm the state of Front End (T1/E1/V35)
	Confirm the Link state

	Check for any error events.


Further Info
------------

	Please contact Sangoma Tech Support
	Tel. 	905 474 1990 ex118 
	Email:  techdesk@sangoma.com