 Harald Welte
|
c5a57a2ab5
|
enlarge board to have proper mounting holes for mechanical mounting
|
2019-12-20 23:43:50 +01:00 |
|
Harald Welte
|
dfe01d45f4
|
squash most parts and avoid silk screen overlaps all over the place
|
2019-12-20 23:35:19 +01:00 |
|
Harald Welte
|
2a8c4c5f33
|
change font to vector / update to v2
|
2019-12-20 23:14:49 +01:00 |
 Martin Schramm
|
15e6f9a81b
|
e1_xcvr.brd: minor routing improvement on TRING signal
|
2018-05-29 20:05:48 +02:00 |
|
Martin Schramm
|
00ebf25701
|
replace old PULSE_T1094NL footprint, repair pin assignment (solves OSM#3269)
|
2018-05-29 19:52:28 +02:00 |
|
Martin Schramm
|
69f96a69ad
|
connect LIU's pin 44 to GND (solves OSM#3247)
|
2018-05-29 13:38:51 +02:00 |
|
Harald Welte
|
ceb70a8260
|
give parts names without "$", use 47nH as L1 (1206)
|
2012-01-14 12:44:58 +01:00 |
|
Harald Welte
|
b8dfc48a37
|
approve lots of warnings about thinner wires
Christan has routed lots of wires thinner than what the network specific
rules state. We approve all of them as we don't care about thinner
wires.
|
2011-12-26 12:59:33 +01:00 |
Christian Vogel
|
5becd7e2fa
|
re-route complete board, add PWR jumper, LED series resistor
|
2011-12-26 12:57:31 +01:00 |
|
Harald Welte
|
07c856afa0
|
re-route pcb with LEDs
|
2011-12-24 17:00:12 +01:00 |
|
Harald Welte
|
a2c23eb8b1
|
re-route the entire board to add test pads and additional components
|
2011-12-24 16:23:08 +01:00 |
|
Harald Welte
|
f4a1d02c6a
|
Add LDO, remove jumpers, 3nd RJ45, ...
|
2011-12-24 02:41:25 +01:00 |
|
Harald Welte
|
547bc5cdec
|
initial checkin
|
2011-12-23 20:57:21 +01:00 |