Mechanical Engineering Change Notes =================================== Revision 0.0 ------------ ### Description Original design ### Manufactured * Two pairs of front/back panels were ordered at [Schaeffer](https://www.schaeffer-ag.de/en/) in 1.5 mm thickness since 1.2 mm is not available. * Back panel was cut at Makilab by @tnt . ### Issues noticed After trying to fit the back panel, it became obvious that the calculations were off and the height of the PCB (1.6 mm) was not properly accounted for, resulting in openings that were all 1.6 mm too low. ### Notes * DXF files were not kept. * Feeds & Speeds in the FreeCAD toolpaths were completely off and were overriden manually. Revision 0.1 ------------ ### Description First revision done after the 1.6 mm offset error was noticed. It was done even before the rev 0.0 panels were back from Schaeffer. ### Changes compared to previous revision * Moved all opening 1.6 mm up. * Size of the 'mouse ears' (for square holes) has been reduced to 2 mm diameter. * Also made sure each square opening is a single poly-line in the DXF. ### Manufactured * Cut two pairs of front/back panels at Makilab for the two proto cases. One of the back panel was the previously 'bad' one (rev 0.0) and so the opening is now too wide and not looking great, but it fits and is functional. ### Issues noticed * The SMA hole height is too low. Nominal height above PCB was 6.4mm but that's for the TE-Connectivity part. The SMA we're using is more like 6.85mm above the surface. To fix this, the hole will be changed to be taller than wide to accomodate both parts. * All the square opening (single RJ45, dual RJ45, USB) have their excess located at the top and have their bottom flush with the expected pcb height. This is different from the circular opening which are aligned on their center. So change the positions so the excess clearance is evenly distributed top/bottom of the expected position. # Notes * Although new FrontPanelDesigner files were made for this revision, they were never submitted / manufactured. Revision 1.0 ------------ ### Description Production version, sent to manufacturer for production. ### Changes compared to previous revision * Converted the SMA opening from a pure-circle to two half circles connected by lines. The upper half circle is 0.5 mm above the previous center * Moved USB, 1xRJ45 and 2xRJ45 opening 0.2 mm down ### Manufactured * A run of 55 cases has been done, with end panels cut by the manufacturer. ### Issues noticed * The cases are nominally 85 mm long, however seems all of them (both from prototype and production were slightly longer by about 0.2-0.4mm). This might be a result of the surface processing. * The SMA hole is very close to the chamfer of the screw hole, leaving very little material between the two and on a couple of panels, it was ripped out or slightly bent by the end-mill during manufacturing. Most panels were fine and some slightly bent one could be corrected, but something to keep in mind. * Also as a consequence of that we can't put a nut on the SMA on the inside (to grab panel by both side). Although I'm not sure it'd be good anyway. The SMA is the only element fixed to the panel (and thus the case), so all the forces of plugging connector are transfered through the PCB, through the SMA to the case. (because the PCB is slightly loose in the case to account for possible tolerances, see also comments in the PCB ECN).