This is just a short help to install the eiconctrl utility.

Make sure your kernel sources are installed (should be /usr/src/linux).

Change into the eiconctrl directory and run

    ./configure

to create the Makefile. Then run

    make

to compile the binaries. The last step is

   make install

to actually install the eiconctrl binary, the man page
and the firmware binaries.

The following options can be used with ./configure

   --with-firmware=DIR
where DIR is the directory to install the firmware binaries.
(default: /usr/lib/isdn/eicon)

   --with-sbin=DIR
where DIR is the directory to install the utility binaries.
(default: /sbin)

   --with-man=DIR
where DIR is the directory to install the man pages.
(default: /usr/man)

   --with-kernel=DIR
where DIR is your kernel source directory.
(default: /usr/src/linux)


If you want to re-configure and re-compile, use 

    make distclean

to set all to default.