osmith
/
wireshark
forked from osmocom/wireshark
1
0
Fork 0
Code Pull Requests Releases Wiki Activity
wireshark/epan/dissectors/errno.c

171 lines
7.7 KiB
C
Raw Blame History

/* errno.c
* String descriptions for errno values.
*
* Wireshark - Network traffic analyzer
* By Gerald Combs <gerald@wireshark.org>
* Copyright 1998 Gerald Combs
*
* SPDX-License-Identifier: GPL-2.0-or-later
*/
#include "config.h"
#include <epan/value_string.h>
/* Note: sorted in (unsigned) ascending order with no gaps to enable direct,
* array-indexed access. */
static const value_string linux_negative_errno_vals[] = {
/* from include/uapi/asm-generic/errno.h */
{ -133, "Memory page has hardware error (-EHWPOISON)" },
{ -132, "Operation not possible due to RF-kill (-ERFKILL)" },
{ -131, "State not recoverable (-ENOTRECOVERABLE)" },
{ -130, "Owner died (-EOWNERDEAD)" },
{ -129, "Key was rejected by service (-EKEYREJECTED)" },
{ -128, "Key has been revoked (-EKEYREVOKED)" },
{ -127, "Key has expired (-EKEYEXPIRED)" },
{ -126, "Required key not available (-ENOKEY)" },
{ -125, "Operation Canceled (-ECANCELED)" },
{ -124, "Wrong medium type (-EMEDIUMTYPE)" },
{ -123, "No medium found (-ENOMEDIUM)" },
{ -122, "Quota exceeded (-EDQUOT)" },
{ -121, "Remote I/O error (-EREMOTEIO)" },
{ -120, "Is a named type file (-EISNAM)" },
{ -119, "No XENIX semaphores available (-ENAVAIL)" },
{ -118, "Not a XENIX named type file (-ENOTNAM)" },
{ -117, "Structure needs cleaning (-EUCLEAN)" },
{ -116, "Stale file handle (-ESTALE)" },
{ -115, "Operation now in progress (-EINPROGRESS)" },
{ -114, "Operation already in progress (-EALREADY)" },
{ -113, "No route to host (-EHOSTUNREACH)" },
{ -112, "Host is down (-EHOSTDOWN)" },
{ -111, "Connection refused (-ECONNREFUSED)" },
{ -110, "Connection timed out (-ETIMEDOUT)" },
{ -109, "Too many references: cannot splice (-ETOOMANYREFS)" },
{ -108, "Cannot send after transport endpoint shutdown (-ESHUTDOWN)" },
{ -107, "Transport endpoint is not connected (-ENOTCONN)" },
{ -106, "Transport endpoint is already connected (-EISCONN)" },
{ -105, "No buffer space available (-ENOBUFS)" },
{ -104, "Connection reset by peer (-ECONNRESET)" },
{ -103, "Software caused connection abort (-ECONNABORTED)" },
{ -102, "Network dropped connection because of reset (-ENETRESET)" },
{ -101, "Network is unreachable (-ENETUNREACH)" },
{ -100, "Network is down (-ENETDOWN)" },
{ -99, "Cannot assign requested address (-EADDRNOTAVAIL)" },
{ -98, "Address already in use (-EADDRINUSE)" },
{ -97, "Address family not supported by protocol (-EAFNOSUPPORT)" },
{ -96, "Protocol family not supported (-EPFNOSUPPORT)" },
{ -95, "Operation not supported on transport endpoint (-EOPNOTSUPP)" },
{ -94, "Socket type not supported (-ESOCKTNOSUPPORT)" },
{ -93, "Protocol not supported (-EPROTONOSUPPORT)" },
{ -92, "Protocol not available (-ENOPROTOOPT)" },
{ -91, "Protocol wrong type for socket (-EPROTOTYPE)" },
{ -90, "Message too long (-EMSGSIZE)" },
{ -89, "Destination address required (-EDESTADDRREQ)" },
{ -88, "Socket operation on non-socket (-ENOTSOCK)" },
{ -87, "Too many users (-EUSERS)" },
{ -86, "Streams pipe error (-ESTRPIPE)" },
{ -85, "Interrupted system call should be restarted (-ERESTART)" },
{ -84, "Illegal byte sequence (-EILSEQ)" },
{ -83, "Cannot exec a shared library directly (-ELIBEXEC)" },
{ -82, "Attempting to link in too many shared libraries (-ELIBMAX)" },
{ -81, ".lib section in a.out corrupted (-ELIBSCN)" },
{ -80, "Accessing a corrupted shared library (-ELIBBAD)" },
{ -79, "Can not access a needed shared library (-ELIBACC)" },
{ -78, "Remote address changed (-EREMCHG)" },
{ -77, "File descriptor in bad state (-EBADFD)" },
{ -76, "Name not unique on network (-ENOTUNIQ)" },
{ -75, "Value too large for defined data type (-EOVERFLOW)" },
{ -74, "Not a data message (-EBADMSG)" },
{ -73, "RFS specific error (-EDOTDOT)" },
{ -72, "Multihop attempted (-EMULTIHOP)" },
{ -71, "Protocol error (-EPROTO)" },
{ -70, "Communication error on send (-ECOMM)" },
{ -69, "Srmount error (-ESRMNT)" },
{ -68, "Advertise error (-EADV)" },
{ -67, "Link has been severed (-ENOLINK)" },
{ -66, "Object is remote (-EREMOTE)" },
{ -65, "Package not installed (-ENOPKG)" },
{ -64, "Machine is not on the network (-ENONET)" },
{ -63, "Out of streams resources (-ENOSR)" },
{ -62, "Timer expired (-ETIME)" },
{ -61, "No data available (-ENODATA)" },
{ -60, "Device not a stream (-ENOSTR)" },
{ -59, "Bad font file format (-EBFONT)" },
{ -58, "(-58 \?\?\?)" }, /* dummy so that there are no "gaps" */
{ -57, "Invalid slot (-EBADSLT)" },
{ -56, "Invalid request code (-EBADRQC)" },
{ -55, "No anode (-ENOANO)" },
{ -54, "Exchange full (-EXFULL)" },
{ -53, "Invalid request descriptor (-EBADR)" },
{ -52, "Invalid exchange (-EBADE)" },
{ -51, "Level 2 halted (-EL2HLT)" },
{ -50, "No CSI structure available (-ENOCSI)" },
{ -49, "Protocol driver not attached (-EUNATCH)" },
{ -48, "Link number out of range (-ELNRNG)" },
{ -47, "Level 3 reset (-EL3RST)" },
{ -46, "Level 3 halted (-EL3HLT)" },
{ -45, "Level 2 not synchronized (-EL2NSYNC)" },
{ -44, "Channel number out of range (-ECHRNG)" },
{ -43, "Identifier removed (-EIDRM)" },
{ -42, "No message of desired type (-ENOMSG)" },
{ -41, "(-41 \?\?\?)" }, /* dummy so that there are no "gaps" */
{ -40, "Too many symbolic links encountered (-ELOOP)" },
{ -39, "Directory not empty (-ENOTEMPTY)" },
{ -38, "Invalid system call number (-ENOSYS)" },
{ -37, "No record locks available (-ENOLCK)" },
{ -36, "File name too long (-ENAMETOOLONG)" },
{ -35, "Resource deadlock would occur (-EDEADLK)" },
/* from include/uapi/asm-generic/errno-base.h */
{ -34, "Math result not representable (-ERANGE)" },
{ -33, "Math argument out of domain of func (-EDOM)" },
{ -32, "Broken pipe (-EPIPE)" },
{ -31, "Too many links (-EMLINK)" },
{ -30, "Read-only file system (-EROFS)" },
{ -29, "Illegal seek (-ESPIPE)" },
{ -28, "No space left on device (-ENOSPC)" },
{ -27, "File too large (-EFBIG)" },
{ -26, "Text file busy (-ETXTBSY)" },
{ -25, "Not a typewriter (-ENOTTY)" },
{ -24, "Too many open files (-EMFILE)" },
{ -23, "File table overflow (-ENFILE)" },
{ -22, "Invalid argument (-EINVAL)" },
{ -21, "Is a directory (-EISDIR)" },
{ -20, "Not a directory (-ENOTDIR)" },
{ -19, "No such device (-ENODEV)" },
{ -18, "Cross-device link (-EXDEV)" },
{ -17, "File exists (-EEXIST)" },
{ -16, "Device or resource busy (-EBUSY)" },
{ -15, "Block device required (-ENOTBLK)" },
{ -14, "Bad address (-EFAULT)" },
{ -13, "Permission denied (-EACCES)" },
{ -12, "Out of memory (-ENOMEM)" },
{ -11, "Try again (-EAGAIN)" },
{ -10, "No child processes (-ECHILD)" },
{ -9, "Bad file number (-EBADF)" },
{ -8, "Exec format error (-ENOEXEC)" },
{ -7, "Argument list too long (-E2BIG)" },
{ -6, "No such device or address (-ENXIO)" },
{ -5, "I/O error (-EIO)" },
{ -4, "Interrupted system call (-EINTR)" },
{ -3, "No such process (-ESRCH)" },
{ -2, "No such file or directory (-ENOENT)" },
{ -1, "Operation not permitted (-EPERM)" },
{ 0, "Success" },
{ 0, NULL }
};
value_string_ext linux_negative_errno_vals_ext = VALUE_STRING_EXT_INIT(linux_negative_errno_vals);
/*
* Editor modelines - https://www.wireshark.org/tools/modelines.html
*
* Local variables:
* c-basic-offset: 4
* tab-width: 8
* indent-tabs-mode: nil
* End:
*
* vi: set shiftwidth=4 tabstop=8 expandtab:
* :indentSize=4:tabSize=8:noTabs=true:
*/
View Git Blame Copy Permalink