If two threads are waiting in find_entry() and remove_entry(),
respectively, and the former is woken first, the latter remains stuck
as it won't get signaled.
If there are threads waiting in find_entry() and one in remove_entry()
and the latter is woken first by a thread calling put_entry(), the
former threads would remain stuck as they get never signaled.
This can happen if an IKE_SA is terminated forcefully shortly before
terminating the daemon. The thread that handles the terminate command
will call checkin_and_destroy(), which unregisters the IKE_SA from the
manager before destroying it. The main thread that calls flush() on the
IKE_SA manager won't wait for this SA (its entry is already gone), so
the processor and in turn the watcher job/thread might get canceled
before the first thread started deleting the VIP. It would then wait
indefinitely for a signal that can never be sent.
There is still a small chance the thread hangs in wait() if the state check
happens right before the watcher is canceled and it wasn't yet able to
deliver the event from the kernel, we counter that by rechecking the state
after a while.
This now includes all key material derived for IKE_SAs in the order
defined in the RFC:
{SK_d | SK_ai | SK_ar | SK_ei | SK_er | SK_pi | SK_pr}
= prf+ (SKEYSEED, Ni | Nr | SPIi | SPIr)
Signed-off-by: Thomas Egerer <thomas.egerer@secunet.com>
Wireshark doesn't really support it, but this way it at least decodes
the ESP packets correctly and the encryption keys are saved and the
packets can be decrypted. The full-length versions of SHA-384 and
SHA-512 are not supported by Wireshark as 256-bit is the longest ICV
it is able to decode currently.
The previous approach would lead to additional zero prefixes in the
encoding of the serial (which is a positive integer, not an arbitrary
blob).
Fixes#3667.
This ensures that e.g. ike/child-updown messages are sent that were
queued but couldn't be sent (even the job to enable to on_write() callback
requires a worker thread that's not around anymore during shutdown).
References #3602.
Note that manually adding an IPv6 address without disabling duplicate
address detection (DAD, e.g. via `nodad` when using iproute2) will cause
a roam event due to a flag change after about 1-2 seconds (TENTATIVE is
removed). If this is a problem, we might have to ignore addresses with
TENTATIVE flag when we receive a RTM_NEWADDR message until that flag is
eventually removed.
Fixes#3511.
This way we only have one reference for each CA certificate, whether it
is loaded in an authority section, a connection or via load-certs() command.
It also avoids enumerating CA certificates multiple times if they are
loaded in different ways.
With the previous approach, CA certificates that were not re-loaded via
load-cert() (e.g. from tokens or via absolute paths) would not be available
anymore after the clear-creds() command was used. This avoids this
issue, but can cause duplicate CA certificates to get stored and enumerated,
so there might be a scaling factor.
The main intention here is that we can change the hashtable_t
implementation without being impeded by the special requirements imposed
by get_match() and sorting the keys/items in buckets.
They are not marked as temporary addresses so make sure we always return
them whether temporary addresses are preferred as source addresses or not
as we need to enumerate them when searching for addresses in traffic selectors
to install routes.
Fixes: 9f12b8a61c ("kernel-netlink: Enumerate temporary IPv6 addresses according to config")
Domonkos P. Tomcsanyi
Andreas Steffen