vici: Correctly document 'up' key for updown events

Instead of sending 'no' it is omitted when an SA goes down.
This commit is contained in:
Tobias Brunner 2016-02-03 16:33:24 +01:00
parent 7823393926
commit fedb16236c
1 changed files with 4 additions and 4 deletions

View File

@ -788,7 +788,7 @@ information during an active_list-authorities_ command.
The _ike-updown_ event is issued when an IKE_SA is established or terminated.
{
up = <yes or no>
up = <set if up event>
<IKE_SA config name> = {
<same data as in the list-sas event, but without child-sas section>
}
@ -814,7 +814,7 @@ The _ike-rekey_ event is issued when an IKE_SA is rekeyed.
The _child-updown_ event is issued when a CHILD_SA is established or terminated.
{
up = <yes or no>
up = <set if up event>
<IKE_SA config name> = {
<same data as in the list-sas event, but with only the affected
CHILD_SA in the child-sas section>
@ -1102,8 +1102,8 @@ subdirectory, and gets built and installed if strongSwan has been
_./configure_'d with_--enable-vici_ and _--enable-perl-cpan_.
The _Vici::Session_ module provides a _new()_ constructor for a high level
interface, the underlying _Vici::Packet_ and _Vici::Transport_ classes are
usually not required to build Perl applications using VICI. The _Vici::Session_
interface, the underlying _Vici::Packet_ and _Vici::Transport_ classes are
usually not required to build Perl applications using VICI. The _Vici::Session_
class provides methods for the supported VICI commands. The auxiliare
_Vici::Message_ class is used to encode configuration parameters sent to
the daemon and decode data returned by the daemon.