You can not select more than 25 topics
Topics must start with a letter or number, can include dashes ('-') and can be up to 35 characters long.
Harald Welte
7b4ddba001
|
5 months ago | |
|---|---|---|
| .. | ||
| README.md | 5 months ago | |
| bgt-keystone6-back.dxf | 5 months ago | |
| bgt-keystone6-front.dxf | 5 months ago | |
| bgt-keystone6.dxf | 5 months ago | |
README.md
3U component carrier module for 6 keystone connectors
This is a mechanical design to mount 6 keystone connectors in a 3U component carrier.
Why would one want to do that? You can get keystone modules inexpensively for virtually any [small] connector, like RJ45, RJ12, BNC, SMA, LC, USB-A, USB-B, ...
You can configure a keystone panel dynamically and quickly for the given use case of connector combinations. No need to do a custom face plate each time, so it's particularly useful in setups you're building once, where the design cost, machine setup cost and production delay of a custom face plate are prohibitive.
The module consists of two panels:
- the face plate to which the keystone modules are flush
- the back plate into which you snap the keystone modules
face plate
6 TE wide face plate
- 128.4 x 30.22 mm
- 14 openings
- 907 mm total path
- 2mm (2.5mm) material, typically AlMg3
back plate
- 110 x 29 mm
- 12 openings
- 763 mm total path
- 1mm material, typically steel
BOM
- 1x face plate (above)
- 1x back plate (above)
- 6x 4mm hexagon spacers with 2mm thread
- 6x M2 countersunk screws (from front side)
- 6x M2 screws (from back side)
- 2x Fischer KN 1
- 2x Fischer HS 1 or RS 1 M2,5x11