![]() Set the hardware interrupt priority to a different value for each attached ColdFire serial port. According to the CPU documentation you should not use the same combination of level/priority on more than one device. People have reported odd serial port behavior with them set the same. Signed-off-by: Greg Ungerer <gerg@uclinux.org> Signed-off-by: Linus Torvalds <torvalds@osdl.org> |
||
---|---|---|
.. | ||
cpm_uart | ||
jsm | ||
8250.c | ||
8250.h | ||
8250_accent.c | ||
8250_acorn.c | ||
8250_acpi.c | ||
8250_au1x00.c | ||
8250_boca.c | ||
8250_early.c | ||
8250_fourport.c | ||
8250_gsc.c | ||
8250_hp300.c | ||
8250_hub6.c | ||
8250_mca.c | ||
8250_pci.c | ||
8250_pnp.c | ||
21285.c | ||
68328serial.c | ||
68328serial.h | ||
68360serial.c | ||
amba-pl010.c | ||
amba-pl011.c | ||
au1x00_uart.c | ||
clps711x.c | ||
crisv10.c | ||
crisv10.h | ||
dz.c | ||
dz.h | ||
icom.c | ||
icom.h | ||
imx.c | ||
ioc4_serial.c | ||
ip22zilog.c | ||
ip22zilog.h | ||
Kconfig | ||
m32r_sio.c | ||
m32r_sio.h | ||
m32r_sio_reg.h | ||
Makefile | ||
mcfserial.c | ||
mcfserial.h | ||
mpc52xx_uart.c | ||
mpsc.c | ||
mpsc.h | ||
mux.c | ||
pmac_zilog.c | ||
pmac_zilog.h | ||
pxa.c | ||
s3c2410.c | ||
sa1100.c | ||
serial_core.c | ||
serial_cs.c | ||
serial_lh7a40x.c | ||
serial_txx9.c | ||
sh-sci.c | ||
sh-sci.h | ||
sn_console.c | ||
suncore.c | ||
suncore.h | ||
sunsab.c | ||
sunsab.h | ||
sunsu.c | ||
sunzilog.c | ||
sunzilog.h | ||
v850e_uart.c | ||
vr41xx_siu.c |