2e7fc3ba68
The logic to allow only one DMA driver in MUSB is currently flawed, because it also allows picking no DMA driver at all and also not selecting PIO mode. Using a choice statement makes this foolproof for now and also simplifies the Makefile. Unfortunately, we will have to revisit this when we start supporting multiple ARM platforms in a single kernel binary, because at that point we will actually need to select multiple DMA drivers and pick the right one at run-time. Signed-off-by: Arnd Bergmann <arnd@arndb.de> Cc: Felipe Balbi <balbi@ti.com> Signed-off-by: Felipe Balbi <balbi@ti.com>
31 lines
1 KiB
Makefile
31 lines
1 KiB
Makefile
#
|
|
# for USB OTG silicon based on Mentor Graphics INVENTRA designs
|
|
#
|
|
|
|
obj-$(CONFIG_USB_MUSB_HDRC) += musb_hdrc.o
|
|
|
|
musb_hdrc-y := musb_core.o
|
|
|
|
musb_hdrc-y += musb_gadget_ep0.o musb_gadget.o
|
|
musb_hdrc-y += musb_virthub.o musb_host.o
|
|
musb_hdrc-$(CONFIG_DEBUG_FS) += musb_debugfs.o
|
|
|
|
# Hardware Glue Layer
|
|
obj-$(CONFIG_USB_MUSB_OMAP2PLUS) += omap2430.o
|
|
obj-$(CONFIG_USB_MUSB_AM35X) += am35x.o
|
|
obj-$(CONFIG_USB_MUSB_TUSB6010) += tusb6010.o
|
|
obj-$(CONFIG_USB_MUSB_DAVINCI) += davinci.o
|
|
obj-$(CONFIG_USB_MUSB_DA8XX) += da8xx.o
|
|
obj-$(CONFIG_USB_MUSB_BLACKFIN) += blackfin.o
|
|
obj-$(CONFIG_USB_MUSB_UX500) += ux500.o
|
|
|
|
# the kconfig must guarantee that only one of the
|
|
# possible I/O schemes will be enabled at a time ...
|
|
# PIO only, or DMA (several potential schemes).
|
|
# though PIO is always there to back up DMA, and for ep0
|
|
|
|
musb_hdrc-$(CONFIG_USB_INVENTRA_DMA) += musbhsdma.o
|
|
musb_hdrc-$(CONFIG_USB_TI_CPPI_DMA) += cppi_dma.o
|
|
musb_hdrc-$(CONFIG_USB_TUSB_OMAP_DMA) += tusb6010_omap.o
|
|
musb_hdrc-$(CONFIG_USB_UX500_DMA) += ux500_dma.o
|