As the mmu write protects guest page table, we emulate those writes. Since
they are not mmio, there is no need to go to userspace to perform them.
So, perform the writes in the kernel if possible, and notify the mmu about
them so it can take the approriate action.
Signed-off-by: Avi Kivity <avi@qumranet.com>
Acked-by: Ingo Molnar <mingo@elte.hu>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
Define a hashtable for caching shadow page tables. Look up the cache on
context switch (cr3 change) or during page faults.
The key to the cache is a combination of
- the guest page table frame number
- the number of paging levels in the guest
* we can cache real mode, 32-bit mode, pae, and long mode page
tables simultaneously. this is useful for smp bootup.
- the guest page table table
* some kernels use a page as both a page table and a page directory. this
allows multiple shadow pages to exist for that page, one per level
- the "quadrant"
* 32-bit mode page tables span 4MB, whereas a shadow page table spans
2MB. similarly, a 32-bit page directory spans 4GB, while a shadow
page directory spans 1GB. the quadrant allows caching up to 4 shadow page
tables for one guest page in one level.
- a "metaphysical" bit
* for real mode, and for pse pages, there is no guest page table, so set
the bit to avoid write protecting the page.
Signed-off-by: Avi Kivity <avi@qumranet.com>
Acked-by: Ingo Molnar <mingo@elte.hu>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
Since we're not going to cache the pae-mode shadow root pages, allocate a
single pae shadow that will hold the four lower-level pages, which will act as
roots.
Signed-off-by: Avi Kivity <avi@qumranet.com>
Acked-by: Ingo Molnar <mingo@elte.hu>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
In pae mode, a load of cr3 loads the four third-level page table entries in
addition to cr3 itself.
Signed-off-by: Avi Kivity <avi@qumranet.com>
Acked-by: Ingo Molnar <mingo@elte.hu>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
Keep in each host page frame's page->private a pointer to the shadow pte which
maps it. If there are multiple shadow ptes mapping the page, set bit 0 of
page->private, and use the rest as a pointer to a linked list of all such
mappings.
Reverse mappings are needed because we when we cache shadow page tables, we
must protect the guest page tables from being modified by the guest, as that
would invalidate the cached ptes.
Signed-off-by: Avi Kivity <avi@qumranet.com>
Acked-by: Ingo Molnar <mingo@elte.hu>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
Hardware virtualization implementations allow the guests to freely change some
of the bits in cr0 and cr4, but trap when changing the other bits. This is
useful to avoid excessive exits due to changing, for example, the ts flag.
It also means the kvm's copy of cr0 and cr4 may be stale with respect to these
bits. most of the time this doesn't matter as these bits are not very
interesting. Other times, however (for example when returning cr0 to
userspace), they are, so get the fresh contents of these bits from the guest
by means of a new arch operation.
Signed-off-by: Avi Kivity <avi@qumranet.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
The current interrupt injection mechanism might delay an interrupt under
the following circumstances:
- if injection fails because the guest is not interruptible (rflags.IF clear,
or after a 'mov ss' or 'sti' instruction). Userspace can check rflags,
but the other cases or not testable under the current API.
- if injection fails because of a fault during delivery. This probably
never happens under normal guests.
- if injection fails due to a physical interrupt causing a vmexit so that
it can be handled by the host.
In all cases the guest proceeds without processing the interrupt, reducing
the interactive feel and interrupt throughput of the guest.
This patch fixes the situation by allowing userspace to request an exit
when the 'interrupt window' opens, so that it can re-inject the interrupt
at the right time. Guest interactivity is very visibly improved.
Signed-off-by: Dor Laor <dor.laor@qumranet.com>
Signed-off-by: Avi Kivity <avi@qumranet.com>
Acked-by: Ingo Molnar <mingo@elte.hu>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
fix an GFP_KERNEL allocation in atomic section: kvm_dev_ioctl_create_vcpu()
called kvm_mmu_init(), which calls alloc_pages(), while holding the vcpu.
The fix is to set up the MMU state in two phases: kvm_mmu_create() and
kvm_mmu_setup().
(NOTE: free_vcpus does an kvm_mmu_destroy() call so there's no need for any
extra teardown branch on allocation/init failure here.)
Signed-off-by: Ingo Molnar <mingo@elte.hu>
Cc: Avi Kivity <avi@qumranet.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
Instead of doing tricky stuff with the arch dependent virtualization
registers, take a peek at the guest's efer.
This simlifies some code, and fixes some confusion in the mmu branch.
Signed-off-by: Avi Kivity <avi@qumranet.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
As per akpm's request.
Signed-off-by: Avi Kivity <avi@qumranet.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
web site: http://kvm.sourceforge.net
mailing list: kvm-devel@lists.sourceforge.net
(http://lists.sourceforge.net/lists/listinfo/kvm-devel)
The following patchset adds a driver for Intel's hardware virtualization
extensions to the x86 architecture. The driver adds a character device
(/dev/kvm) that exposes the virtualization capabilities to userspace. Using
this driver, a process can run a virtual machine (a "guest") in a fully
virtualized PC containing its own virtual hard disks, network adapters, and
display.
Using this driver, one can start multiple virtual machines on a host.
Each virtual machine is a process on the host; a virtual cpu is a thread in
that process. kill(1), nice(1), top(1) work as expected. In effect, the
driver adds a third execution mode to the existing two: we now have kernel
mode, user mode, and guest mode. Guest mode has its own address space mapping
guest physical memory (which is accessible to user mode by mmap()ing
/dev/kvm). Guest mode has no access to any I/O devices; any such access is
intercepted and directed to user mode for emulation.
The driver supports i386 and x86_64 hosts and guests. All combinations are
allowed except x86_64 guest on i386 host. For i386 guests and hosts, both pae
and non-pae paging modes are supported.
SMP hosts and UP guests are supported. At the moment only Intel
hardware is supported, but AMD virtualization support is being worked on.
Performance currently is non-stellar due to the naive implementation of the
mmu virtualization, which throws away most of the shadow page table entries
every context switch. We plan to address this in two ways:
- cache shadow page tables across tlb flushes
- wait until AMD and Intel release processors with nested page tables
Currently a virtual desktop is responsive but consumes a lot of CPU. Under
Windows I tried playing pinball and watching a few flash movies; with a recent
CPU one can hardly feel the virtualization. Linux/X is slower, probably due
to X being in a separate process.
In addition to the driver, you need a slightly modified qemu to provide I/O
device emulation and the BIOS.
Caveats (akpm: might no longer be true):
- The Windows install currently bluescreens due to a problem with the
virtual APIC. We are working on a fix. A temporary workaround is to
use an existing image or install through qemu
- Windows 64-bit does not work. That's also true for qemu, so it's
probably a problem with the device model.
[bero@arklinux.org: build fix]
[simon.kagstrom@bth.se: build fix, other fixes]
[uril@qumranet.com: KVM: Expose interrupt bitmap]
[akpm@osdl.org: i386 build fix]
[mingo@elte.hu: i386 fixes]
[rdreier@cisco.com: add log levels to all printks]
[randy.dunlap@oracle.com: Fix sparse NULL and C99 struct init warnings]
[anthony@codemonkey.ws: KVM: AMD SVM: 32-bit host support]
Signed-off-by: Yaniv Kamay <yaniv@qumranet.com>
Signed-off-by: Avi Kivity <avi@qumranet.com>
Cc: Simon Kagstrom <simon.kagstrom@bth.se>
Cc: Bernhard Rosenkraenzer <bero@arklinux.org>
Signed-off-by: Uri Lublin <uril@qumranet.com>
Cc: Ingo Molnar <mingo@elte.hu>
Cc: Roland Dreier <rolandd@cisco.com>
Signed-off-by: Randy Dunlap <randy.dunlap@oracle.com>
Signed-off-by: Anthony Liguori <anthony@codemonkey.ws>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
Avi Kivity