Higher layers sometimes call set_page_dirty without asking the filesystem
to help. This causes many problems for the data=ordered and cow code.
This commit detects pages that haven't been properly setup for IO and
kicks off an async helper to deal with them.
Signed-off-by: Chris Mason <chris.mason@oracle.com>
The old data=ordered code would force commit to wait until
all the data extents from the transaction were fully on disk. This
introduced large latencies into the commit and stalled new writers
in the transaction for a long time.
The new code changes the way data allocations and extents work:
* When delayed allocation is filled, data extents are reserved, and
the extent bit EXTENT_ORDERED is set on the entire range of the extent.
A struct btrfs_ordered_extent is allocated an inserted into a per-inode
rbtree to track the pending extents.
* As each page is written EXTENT_ORDERED is cleared on the bytes corresponding
to that page.
* When all of the bytes corresponding to a single struct btrfs_ordered_extent
are written, The previously reserved extent is inserted into the FS
btree and into the extent allocation trees. The checksums for the file
data are also updated.
Signed-off-by: Chris Mason <chris.mason@oracle.com>
This makes it possible for callers to check for extent_buffers in cache
without deadlocking against any btree locks held.
Signed-off-by: Chris Mason <chris.mason@oracle.com>
The allocation trees and the chunk trees are serialized via their own
dedicated mutexes. This means allocation location is still not very
fine grained.
The main FS btree is protected by locks on each block in the btree. Locks
are taken top / down, and as processing finishes on a given level of the
tree, the lock is released after locking the lower level.
The end result of a search is now a path where only the lowest level
is locked. Releasing or freeing the path drops any locks held.
Signed-off-by: Chris Mason <chris.mason@oracle.com>
The extent_io writepage calls needed an extra check for discarding
pages that started on th last byte in the file.
btrfs_truncate_page needed checks to make sure the page was still part
of the file after reading it, and most importantly, needed to wait for
all IO to the page to finish before freeing the corresponding extents on
disk.
Signed-off-by: Chris Mason <chris.mason@oracle.com>
When duplicate copies exist, writes are allowed to fail to one of those
copies. This changeset includes a few changes that allow the FS to
continue even when some IOs fail.
It also adds verification of the parent generation number for btree blocks.
This generation is stored in the pointer to a block, and it ensures
that missed writes to are detected.
Signed-off-by: Chris Mason <chris.mason@oracle.com>
The generic O_DIRECT code assumes all the bios have the same bdev,
which isn't true for multi-device btrfs.
Signed-off-by: Chris Mason <chris.mason@oracle.com>
The btree inode should only have a single extent_map in the cache,
it doesn't make sense to ever drop it.
Signed-off-by: Chris Mason <chris.mason@oracle.com>
The data read retry code needs to find the logical disk block before it
can resubmit new bios. But, finding this block isn't allowed to take
the fs_mutex because that will deadlock with a number of different callers.
This changes the retry code to use the extent map cache instead, but
that requires the extent map cache to have the extent we're looking for.
This is a problem because btrfs_drop_extent_cache just drops the entire
extent instead of the little tiny part it is invalidating.
The bulk of the code in this patch changes btrfs_drop_extent_cache to
invalidate only a portion of the extent cache, and changes btrfs_get_extent
to deal with the results.
Signed-off-by: Chris Mason <chris.mason@oracle.com>
Before, metadata checksumming was done by the callers of read_tree_block,
which would set EXTENT_CSUM bits in the extent tree to show that a given
range of pages was already checksummed and didn't need to be verified
again.
But, those bits could go away via try_to_releasepage, and the end
result was bogus checksum failures on pages that never left the cache.
The new code validates checksums when the page is read. It is a little
tricky because metadata blocks can span pages and a single read may
end up going via multiple bios.
Signed-off-by: Chris Mason <chris.mason@oracle.com>
When we checkum file data during writepage, the checksumming is done one
page at a time, making it difficult to do bulk metadata modifications
to insert checksums for large ranges of the file at once.
This patch changes btrfs to checksum on a per-bio basis instead. The
bios are checksummed before they are handed off to the block layer, so
each bio is contiguous and only has pages from the same inode.
Checksumming on a bio basis allows us to insert and modify the file
checksum items in large groups. It also allows the checksumming to
be done more easily by async worker threads.
Signed-off-by: Chris Mason <chris.mason@oracle.com>
Reduce CPU time searching for free blocks by optimizing find_first_extent_bit
Fix find_free_extent to make better use of the last_alloc hint. Before it
was often finding blocks just before the hint.
Signed-off-by: Chris Mason <chris.mason@oracle.com>
A few codes were not properly updated for changes of extent map. This
may be the causes of "no csum found for inode" issue.
Signed-off-by: Chris Mason <chris.mason@oracle.com>
The end_bio routines are changed to take a pointer to the extent state
struct, and the state tree is walked in order to set/clear appropriate
bits as IO completes. This greatly reduces the number of rbtree searches
done by the end_bio handlers, and reduces lock contention.
The extent_io releasepage function is changed to avoid expensive searches
for locked state.
Signed-off-by: Chris Mason <chris.mason@oracle.com>
There is now extent_map for mapping offsets in the file to disk and
extent_io for state tracking, IO submission and extent_bufers.
The new extent_map code shifts from [start,end] pairs to [start,len], and
pushes the locking out into the caller. This allows a few performance
optimizations and is easier to use.
A number of extent_map usage bugs were fixed, mostly with failing
to remove extent_map entries when changing the file.
Signed-off-by: Chris Mason <chris.mason@oracle.com>
Chris Mason