[SCSI] hpsa: Fix problem with MSA2xxx devices
Upgraded firmware on Smart Array P7xx (and some others) made them show up as SCSI revision 5 devices and this caused the driver to fail to map MSA2xxx logical drives to the correct bus/target/lun. A symptom of this would be that the target ID of the logical drives as presented by the external storage array is ignored, and all such logical drives are assigned to target zero, differentiated only by LUN. Some multipath software reportedly does not deal well with this behavior, failing to recognize different paths to the same device as such. Signed-off-by: Stephen M. Cameron <scameron@beardog.cce.hp.com> Signed-off-by: Scott Teel <scott.teel@hp.com> Signed-off-by: James Bottomley <JBottomley@Parallels.com>
This commit is contained in:
parent
f79cfec6b1
commit
9bc3711cbb
1 changed files with 16 additions and 20 deletions
|
@ -1637,30 +1637,26 @@ static void figure_bus_target_lun(struct ctlr_info *h,
|
|||
|
||||
if (is_logical_dev_addr_mode(lunaddrbytes)) {
|
||||
/* logical device */
|
||||
if (unlikely(is_scsi_rev_5(h))) {
|
||||
/* p1210m, logical drives lun assignments
|
||||
* match SCSI REPORT LUNS data.
|
||||
lunid = le32_to_cpu(*((__le32 *) lunaddrbytes));
|
||||
if (is_msa2xxx(h, device)) {
|
||||
/* msa2xxx way, put logicals on bus 1
|
||||
* and match target/lun numbers box
|
||||
* reports.
|
||||
*/
|
||||
lunid = le32_to_cpu(*((__le32 *) lunaddrbytes));
|
||||
*bus = 0;
|
||||
*target = 0;
|
||||
*lun = (lunid & 0x3fff) + 1;
|
||||
*bus = 1;
|
||||
*target = (lunid >> 16) & 0x3fff;
|
||||
*lun = lunid & 0x00ff;
|
||||
} else {
|
||||
/* not p1210m... */
|
||||
lunid = le32_to_cpu(*((__le32 *) lunaddrbytes));
|
||||
if (is_msa2xxx(h, device)) {
|
||||
/* msa2xxx way, put logicals on bus 1
|
||||
* and match target/lun numbers box
|
||||
* reports.
|
||||
*/
|
||||
*bus = 1;
|
||||
*target = (lunid >> 16) & 0x3fff;
|
||||
*lun = lunid & 0x00ff;
|
||||
} else {
|
||||
/* Traditional smart array way. */
|
||||
if (likely(is_scsi_rev_5(h))) {
|
||||
/* All current smart arrays (circa 2011) */
|
||||
*bus = 0;
|
||||
*target = 0;
|
||||
*lun = (lunid & 0x3fff) + 1;
|
||||
} else {
|
||||
/* Traditional old smart array way. */
|
||||
*bus = 0;
|
||||
*lun = 0;
|
||||
*target = lunid & 0x3fff;
|
||||
*lun = 0;
|
||||
}
|
||||
}
|
||||
} else {
|
||||
|
|
Reference in a new issue