From 6efb0ffe09bec45397142da8e1197885f562e7fa Mon Sep 17 00:00:00 2001 From: Manu Abraham Date: Mon, 15 Oct 2007 12:08:20 -0300 Subject: [PATCH] V4L/DVB (9421): We must wait for the PLL to stabilize Thanks to Peter for the in depth explanation Signed-off-by: Manu Abraham Signed-off-by: Mauro Carvalho Chehab --- drivers/media/dvb/ttpci/budget-ci.c | 23 +++++++++++++++++++++++ 1 file changed, 23 insertions(+) diff --git a/drivers/media/dvb/ttpci/budget-ci.c b/drivers/media/dvb/ttpci/budget-ci.c index 6b77b123f75..21f5e2c6b4c 100644 --- a/drivers/media/dvb/ttpci/budget-ci.c +++ b/drivers/media/dvb/ttpci/budget-ci.c @@ -1768,6 +1768,29 @@ static void frontend_init(struct budget_ci *budget_ci) break; case 0x1019: // TT S2-3200 PCI + /* + * NOTE! on some STB0899 versions, the internal PLL takes a longer time + * to settle, aka LOCK. On the older revisions of the chip, we don't see + * this, as a result on the newer chips the entire clock tree, will not + * be stable after a freshly POWER 'ed up situation. + * In this case, we should RESET the STB0899 (Active LOW) and wait for + * PLL stabilization. + * + * On the TT S2 3200 and clones, the STB0899 demodulator's RESETB is + * connected to the SAA7146 GPIO, GPIO2, Pin 142 + */ + /* Reset Demodulator */ + saa7146_setgpio(budget->dev, 2, SAA7146_GPIO_OUTLO); + /* Wait for everything to die */ + msleep(50); + /* Pull it up out of Reset state */ + saa7146_setgpio(budget->dev, 2, SAA7146_GPIO_OUTHI); + /* Wait for PLL to stabilize */ + msleep(250); + /* + * PLL state should be stable now. Ideally, we should check + * for PLL LOCK status. But well, never mind! + */ budget_ci->budget.dvb_frontend = dvb_attach(stb0899_attach, &tt3200_config, &budget_ci->budget.i2c_adap); if (budget_ci->budget.dvb_frontend) { if (dvb_attach(stb6100_attach, budget_ci->budget.dvb_frontend, &tt3200_stb6100_config, &budget_ci->budget.i2c_adap)) {