MNCC<->SIP bridge; attaches to OsmoMSC to interface with external SIP VoIP telephony
https://osmocom.org/projects/osmo-sip-conector
Oliver Smith
b544ea396a
Verify is the parsed data is at least the size of the struct, not
exactly the size. Make it accept messages with additional data, like
the SDP information the TTCN-3 testsuite is sending since
Ic9568c8927507e161aadfad1a4d20aa896d8ae30.
This change makes the size checks consistent with the two other size
checks in the file:
if (rc < sizeof(*rtp)) {
if (rc < sizeof(**mncc)) {
Related: OS#4282
Change-Id: I522ce7f206932a816a64f03d916799c3215bb8c7
|
||
|---|---|---|
| contrib | ||
| debian | ||
| doc | ||
| src | ||
| tests | ||
| .gitignore | ||
| .gitreview | ||
| COPYING | ||
| Makefile.am | ||
| README.asciidoc | ||
| configure.ac | ||
| git-version-gen | ||
| osmoappdesc.py | ||
README.asciidoc
Osmo SIP Connector ================== Simple utility to map MNCC to SIP and SIP to MNCC. The VTY interface can be used to make configurations. The code doesn't have any RTP or transcoding support. Call identities can be either the MSISDN or the IMSI of the subscriber. Requirements of Equipment ^^^^^^^^^^^^^^^^^^^^^^^^^ * DTMF need to be sent using SIP INFO messages. DTMF in RTP is not supported. * BTS+PBX and SIP connector+PBX must be in the same network (UDP must be able to flow directly between these elements) * No handover support. * IP based BTS (e.g. Sysmocom sysmoBTS but no Siemens BS11) * No emergency calls Limitations ^^^^^^^^^^^ * PT of RTP needs to match the one used by the BTS. E.g. AMR needs to use the same PT as the BTS. This is because rtp_payload2 is not yet supported by the osmo-bts software. * AMR SDP file doesn't include the mode-set params and allowed codec modes. This needs to be configured in some way.