MNCC<->SIP bridge; attaches to OsmoMSC to interface with external SIP VoIP telephony https://osmocom.org/projects/osmo-sip-conector
Go to file
Pau Espin 55faf38675 Bump version: 1.1.0.11-11a0-dirty → 1.1.1
Change-Id: Iefb8ada270a7a34d5db1c1e3c94f72a02e2dd609
2018-05-06 17:45:55 +02:00
contrib contrib: jenkins.sh: Disable doxygen in libosmocore build 2018-02-20 20:23:10 +01:00
debian Bump version: 1.1.0.11-11a0-dirty → 1.1.1 2018-05-06 17:45:55 +02:00
doc/examples vty: Work on configuration of the MNCC to SIP gateway 2016-03-21 15:39:41 +01:00
src use osmo_init_logging2() to avoid allocating from NULL context 2018-04-15 22:15:25 +02:00
tests distcheck/tests: Add the referenced osmoappdesc.py for testing 2016-04-24 22:28:35 +02:00
.gitignore Use release helper from libosmocore 2017-08-26 05:56:55 +00:00
.gitreview Add git review config 2017-08-25 18:38:05 +02:00
COPYING Initial commit for a MNCC to SIP gateway (and maybe auth GW too) 2016-03-21 09:54:37 +01:00
Makefile.am Use release helper from libosmocore 2017-08-26 05:56:55 +00:00
README.asciidoc Write down some of the limitations of the current setup 2016-03-26 16:31:00 +01:00
configure.ac Bump version: 1.1.0.11-11a0-dirty → 1.1.1 2018-05-06 17:45:55 +02:00
git-version-gen Fix git-version-gen 2017-10-28 18:20:00 +02:00
osmoappdesc.py osmoappdesc: Fix VTY prompt to use OsmoSIPcon, not old OsmoMNCC 2018-03-27 15:51:02 +02:00

README.asciidoc

Osmo SIP Connector
==================

Simple utility to map MNCC to SIP and SIP to MNCC. The VTY interface
can be used to make configurations. The code doesn't have any RTP or
transcoding support.

Call identities can be either the MSISDN or the IMSI of the subscriber.


Requirements of Equipment
^^^^^^^^^^^^^^^^^^^^^^^^^

* DTMF need to be sent using SIP INFO messages. DTMF in RTP is not
supported.

* BTS+PBX and SIP connector+PBX  must be in the same network (UDP must be
able to flow directly between these elements)

* No handover support.

* IP based BTS (e.g. Sysmocom sysmoBTS but no Siemens BS11)

* No emergency calls

Limitations
^^^^^^^^^^^

* PT of RTP needs to match the one used by the BTS. E.g. AMR needs to use
the same PT as the BTS. This is because rtp_payload2 is not yet supported
by the osmo-bts software.

* AMR SDP file doesn't include the mode-set params and allowed codec modes.
This needs to be configured in some way.