MNCC<->SIP bridge; attaches to OsmoMSC to interface with external SIP VoIP telephony
https://osmocom.org/projects/osmo-sip-conector
Keith Whyte
364f237b42
* Add GCR to mncc struct and therefore bump mncc version. * Pass the GCR as a SIP Header to SIP UA and retrieve any such header from incoming SIP calls, passing the GCR on to MNCC Related: #OS5164 Depends: osmo-msc I705c860e51637b4537cad65a330ecbaaca96dd5b Change-Id: Id40d7e0fed9356f801b3627c118150055e7232b1 |
||
---|---|---|
contrib | ||
debian | ||
doc | ||
src | ||
tests | ||
.gitignore | ||
.gitreview | ||
COPYING | ||
Makefile.am | ||
README.asciidoc | ||
configure.ac | ||
git-version-gen | ||
osmoappdesc.py |
README.asciidoc
Osmo SIP Connector ================== Simple utility to map MNCC to SIP and SIP to MNCC. The VTY interface can be used to make configurations. The code doesn't have any RTP or transcoding support. Call identities can be either the MSISDN or the IMSI of the subscriber. Requirements of Equipment ^^^^^^^^^^^^^^^^^^^^^^^^^ * DTMF need to be sent using SIP INFO messages. DTMF in RTP is not supported. * BTS+PBX and SIP connector+PBX must be in the same network (UDP must be able to flow directly between these elements) * No handover support. * IP based BTS (e.g. Sysmocom sysmoBTS but no Siemens BS11) * No emergency calls Limitations ^^^^^^^^^^^ * PT of RTP needs to match the one used by the BTS. E.g. AMR needs to use the same PT as the BTS. This is because rtp_payload2 is not yet supported by the osmo-bts software. * AMR SDP file doesn't include the mode-set params and allowed codec modes. This needs to be configured in some way.