MNCC<->SIP bridge; attaches to OsmoMSC to interface with external SIP VoIP telephony https://osmocom.org/projects/osmo-sip-conector
Go to file
Neels Hofmeyr 0294e38243 SIP re-INVITE: fix media connection change detection
Use the correct variable in address comparison.
The type cast hid the incompatible type from the compiler.

Change-Id: I701150f22f0eb49fae821996358568d60a385035
2021-06-01 04:16:19 +02:00
contrib Bump version: 1.4.1.15-9484-dirty → 1.5.0 2021-02-23 13:42:08 +01:00
debian Bump version: 1.4.1.15-9484-dirty → 1.5.0 2021-02-23 13:42:08 +01:00
doc debian: create -doc subpackage with pdf manuals 2019-05-29 12:14:22 +02:00
src SIP re-INVITE: fix media connection change detection 2021-06-01 04:16:19 +02:00
tests distcheck/tests: Add the referenced osmoappdesc.py for testing 2016-04-24 22:28:35 +02:00
.gitignore .gitignore: Get rid of new autofoo tmp files 2021-02-02 16:42:12 +01:00
.gitreview Add git review config 2017-08-25 18:38:05 +02:00
COPYING Initial commit for a MNCC to SIP gateway (and maybe auth GW too) 2016-03-21 09:54:37 +01:00
Makefile.am Makefile.am: EXTRA_DIST: debian, contrib/*.spec.in 2020-05-22 13:46:54 +02:00
README.asciidoc Write down some of the limitations of the current setup 2016-03-26 16:31:00 +01:00
configure.ac Bump version: 1.4.1.15-9484-dirty → 1.5.0 2021-02-23 13:42:08 +01:00
git-version-gen Fix git-version-gen 2017-10-28 18:20:00 +02:00
osmoappdesc.py osmoappdesc.py: switch to python 3 2019-12-11 09:43:11 +01:00

README.asciidoc

Osmo SIP Connector
==================

Simple utility to map MNCC to SIP and SIP to MNCC. The VTY interface
can be used to make configurations. The code doesn't have any RTP or
transcoding support.

Call identities can be either the MSISDN or the IMSI of the subscriber.


Requirements of Equipment
^^^^^^^^^^^^^^^^^^^^^^^^^

* DTMF need to be sent using SIP INFO messages. DTMF in RTP is not
supported.

* BTS+PBX and SIP connector+PBX  must be in the same network (UDP must be
able to flow directly between these elements)

* No handover support.

* IP based BTS (e.g. Sysmocom sysmoBTS but no Siemens BS11)

* No emergency calls

Limitations
^^^^^^^^^^^

* PT of RTP needs to match the one used by the BTS. E.g. AMR needs to use
the same PT as the BTS. This is because rtp_payload2 is not yet supported
by the osmo-bts software.

* AMR SDP file doesn't include the mode-set params and allowed codec modes.
This needs to be configured in some way.