45 lines
1.7 KiB
Plaintext
45 lines
1.7 KiB
Plaintext
==== Full example of QoS for osmo-pcu uplink QoS
|
|
|
|
In the below example we will show the full set of configuration required
|
|
for both DSCP and PCP differentiation of uplink Gb traffic by osmo-pcu.
|
|
|
|
What we want to achieve in this example is the following configuration:
|
|
|
|
.DSCP and PCP assignments for osmo-bts uplink traffic in this example
|
|
[options="header",width="30%",cols="2,1,1"]
|
|
|===
|
|
|Traffic |DSCP|PCP
|
|
|Gb (NS) | 10| 1
|
|
|===
|
|
|
|
. configure the osmocom program to set the DSCP value
|
|
* osmo-pcu.cfg: `dscp 10` in `udp bind` vty node
|
|
. configure an egrees QoS map to map from priority to PCP
|
|
|
|
.Example Step 1: add related VTY configuration to `osmo-pcu.cfg`
|
|
----
|
|
...
|
|
pcu
|
|
gb ip-dscp 10
|
|
gb socket-priority 1
|
|
...
|
|
----
|
|
|
|
.Example Step 2: egress QoS map to map from DSCP values to priority values
|
|
----
|
|
$ sudo ip link set dev eth0.9<1> type vlan egress-qos-map 0:0 1:1 5:5 6:6 7:7 <2>
|
|
----
|
|
<1> make sure to specify your specific VLAN interface name here instead of `eth0.9`.
|
|
<2> create a egress QoS map that maps the priority value 1:1 to the PCP. We also
|
|
include the mappings for 5, 6, and 7 from the osmo-bts example here (see
|
|
<<userman-osmobts>>).
|
|
|
|
NOTE:: The settings of the `ip` command are volatile and only active until
|
|
the next reboot (or the network device or VLAN is removed). Please refer to
|
|
the documentation of your specific Linux distribution in order to find out how
|
|
to make such settings persistent by means of an `ifup` hook whenever the interface
|
|
comes up. For CentOS/RHEL 8 this can e.g. be achieved by means of an `/sbin/ifup-local
|
|
script` (when using `network-scripts` and not NetworkManager). For Debian or Ubuntu,
|
|
this typically involves adding `up` lines to `/etc/network/interfaces` or a `/etc/network/if-up.d`
|
|
script.
|