This patch includes several osmux fixes that are interdependent:
1) This adds Osmux circuit ID, this is allocated from the bsc-nat. This
announces the circuit ID in the CRCX MGCP message. This aims to resolve
the lack of uniqueness due to the use of endp->ci, which is local to
the bsc. This ID is notified via X-Osmux: NUM where NUM is the osmux
circuit ID.
2) The dummy load routines are now used to setup osmux both in bsc and
bsc-nat to resolve source port NAT issues as suggested by Holger. The
source port that is used from the bsc is not known until the first
voice message is sent to the bsc-nat, therefore enabling osmux from
the MGCP plane breaks when a different source port is used.
3) Add refcnt to struct osmux_handle, several endpoints can be using the
same input RTP osmux handle to perform the batching. Remove it from the
osmux handle list once nobody is using it anymore to clean it up.
4) Add a simple Osmux state-machine with three states. The initial state
is disabled, then if the bsc-nat requests Osmux, both sides enters
activating. The final enabled state is reached once the bsc-nat sees
the dummy load message that tells what source port is used by the bsc.
5) The osmux input handle (which transforms RTP messages to one Osmux batch)
is now permanently attached to the endpoint when Osmux is set up from the
dummy load path, so we skip a lookup for each message. This simplifies
osmux_xfrm_to_osmux().
After this patch, the workflow to setup Osmux is the following:
bsc bsc-nat
| |
|<------ CRCX ----------|
| X-Osmux: 3 | (where 3 is the Osmux circuit ID
| | that the bsc-nat has allocated)
|------- resp --------->|
| X-Osmux: 3 | (the bsc confirm that it can
| | use Osmux).
. .
| |
setup osmux |----- dummy load ----->| setup osmux
| Osmux CID: 3 |
In two steps:
1st) Allocate the Osmux Circuit ID (CID): The bsc-nat allocates an unique
Osmux CID that is notified to the bsc through the 'X-Osmux:' extension.
The bsc-nat annotates this circuit ID in the endpoint object. The bsc
replies back with the 'X-Osmux:' to confirm that it agrees to use Osmux.
If the bsc doesn't want to use Osmux, it doesn't include the extension
so the bsc-nat knows that it has to use to RTP.
2nd) The dummy load is used to convey the Osmux CID. This needs to happen
at this stage since the bsc-nat needs to know what source port the bsc
uses to get this working since the bsc may use a different source
port due to NAT. Unfortunately, this can't be done from the MGCP signal
plane since the real source port is not known that the bsc uses is not
known.
This patch also reverts the MDCX handling until it is clear that we need
this special handling for this case.
b769f3ce0b