... while asking the BTS to perform tests for us. The length of the
ARFCN whitelist is the actual length in bytes, not the number of 16bit
ARFCN numbers.
Also, implement a limit, either by rxlevel or by number of ARFCN
that should end up in the whitelist.
Also, we now re-start the network listen test after it has finished,
so if you run a test from ipaccess-find, the test will get re-started
and re-started all the time.
there are now human-readable names so you can do something like
ipaccess-config -U dhcp-enabled -S static-ip -S static-gw 192.168.100.120
to unset DHCP and to set static IP and gateway attributes.
This looks so much better than the *cur++ type code.
Also, we now terminate ipaccess-config once the NV flags or Unit ID have
been set, not just for the OML IP address.
We will tell the BTS where we are listening, but the ACK
will return the original settings... this should make it
possible to intercept the GPRS stream..
This is a good interim solution for messages not handled by us,
right now this would include the NVRAM attributes that I do not
feel like caching right now.
For the multi TRX setup we will need to specify the right trx->nr
to be able to flash the BTS. For the BS11 case we are ignoring the
additional argument.
Send the IPA Restart to a given BTS/TRX, change the signal callbacks
to carry the trx instead of the BTS so we have an easy access to the
right TRX and change the ipaccess-config to use that TRX. This is
fixing the restart with a multi TRX setup.
Even if we have the msg->trx, use the gsm_bts_trx_by_nr and get
the TRX from the fom header. This is because the OpenBSC and the
BTS numbering might not match for the multi TRX case.
Currently we are connecting to the BTS and once the OML is established
we are bootstrapping the OML. This does not work for a multi TRX setup
as we will need to use a trx_nr != 0 for it.
Change the code to wait for a message (in this case NM OC_BASEBAND_TRANSC)
to detect the trx_nr used by the BTS and then use that TRX to bootstrap
the network.
I have tested setting the unit id on a single and multi trx system for
the first and second trx.
The logging/debugging code is generic enough to move it into libosmocore
while keeping OpenBSC specific definitions in openbsc itself.
This commit uses the logging support present in libosmocore-0.1.2,
you will have to update your library to this version.
Currently one has to put -w in front of -f to really write the
firmware file to disk. Change the config handling to first take
all parameters and then execute on them. This means -f can now
be used with any other parameter.
Use the start address inside the header entry, the start is relative
to the surrounding SDP record which is located in our base offset, when
writing it out also ignore four bytes of something (crc?).
* The length of the table is not at a fixed position. We will need
to read the offset, seek there, read the data, convert it to the
host endianes.
* Prepare the code to work with offsets of 0...
Harald Welte
Holger Hans Peter Freyther