osmo-gsm-tester/example
Pau Espin 5686602a98 resources.conf: Set UHD identifiers on B200 devices
osmo-trx-uhd uses these args during device search/selection process. As
those were not set until now for B200, it means when a B200 was used by
osmo-gsm-tester any UHD device could be picked up and used by UHD.
That was actually happening since inclusion of UmTRX devices in Prod
setup, when running tests against desired B200, actually the UmTRX
device was being used.

Change-Id: I696bbc800b05fdd9a68a77f363d76dcc53ef24ee
2018-11-23 13:42:36 +00:00
..
scenarios resurces.conf.prod: Add UmTRX device 2018-11-09 13:34:18 +00:00
README.txt put the example suite in /example, not /selftest/real_suite 2017-05-04 16:42:50 +02:00
default-suites.conf default-suites: Enable tests for LimeSDR-USB 2018-11-18 20:30:02 +00:00
defaults.conf Add support to enable EGPRS 2018-10-31 09:59:45 +01:00
paths.conf paths: have one common parent dir /var/tmp/osmo-gsm-tester 2017-05-11 17:39:02 +02:00
resources.conf.prod resources.conf: Set UHD identifiers on B200 devices 2018-11-23 13:42:36 +00:00
resources.conf.rnd resources.conf: Set UHD identifiers on B200 devices 2018-11-23 13:42:36 +00:00

README.txt

This a real gsm test suite configured and ready to use.
The only thing missing is a trial dir containing binaries.

You can point osmo-gsm-tester.py at this config using the OSMO_GSM_TESTER_CONF
environment variable:

    export OSMO_GSM_TESTER_CONF="$PWD"

When there is no OSMO_GSM_TESTER_CONF set, osmo-gsm-tester will instead look
for conf files in several locations like ~/.config/osmo-gsm-tester,
/usr/local/etc/osmo-gsm-tester, /etc/osmo-gsm-tester.

If you have your trial with binary tar archives in ~/my_trial
you can run the suite for example like this:

    osmo-gsm-tester.py ~/my_trial

Specifically, from this dir:

    OSMO_GSM_TESTER_CONF="$PWD" ../src/osmo-gsm-tester.py ~/my_trial

Alternatively you can setup this example as permanent config using something
like:

    mkdir -p ~/.config
    ln -s "$PWD" ~/.config/osmo-gsm-tester

A ./state dir will be created to store the current osmo-gsm-tester state. If
you prefer not to write to $PWD, set up an own configuration pointing at a
different path (see paths.conf: 'state_dir').