Harald Welte
986efc8698
RBS2000: Make sure we transmit SABM at 0.3 second intervals
...
This is apparently the right timing to increase the chance that the RBS detects
it quickly. (10..15 seconds)
2011-02-13 15:49:26 +01:00
Harald Welte
60acee2152
OM2000: Use om2k in VTY prompt
2011-02-13 15:49:26 +01:00
Harald Welte
4a8f22e470
OM2000: Add IS Conf Req
2011-02-13 15:49:26 +01:00
Harald Welte
6d5a039f71
OM2000: Add enable/disable commands
2011-02-13 15:49:26 +01:00
Harald Welte
091ae8f630
OM2000: Fix Negotiation parsing
2011-02-13 15:49:26 +01:00
Harald Welte
5f4965639c
OM2000: Implement proper parsing and response for Negotiation
2011-02-13 15:49:26 +01:00
Harald Welte
40ad3b33dd
OM2000: Add support for sending the TEST REQUEST message
2011-02-13 15:49:25 +01:00
Harald Welte
fe59e070db
OML2000: Make sure we can properly exit the VTY node
2011-02-13 15:49:25 +01:00
Harald Welte
422a7817a2
OM2000: Make sure we can properly exit tye VTY node
2011-02-13 15:49:25 +01:00
Harald Welte
9bf8e9e2b7
OM2000: Add VTY commands for connect/disconnect and op_info
2011-02-13 15:49:25 +01:00
Harald Welte
fc61a3fe03
OM2000: Add missing file from previous commit
2011-02-13 15:49:25 +01:00
Harald Welte
1d5a206649
OM2000: Introduce VTY commands to initiate OM2000 procedures
2011-02-13 15:49:25 +01:00
Harald Welte
4f3644b84a
OM2000: Negotiation Resposne, send START on OML-up event
2011-02-13 15:49:25 +01:00
Harald Welte
8f909d5134
OM2000: Fix computation of length field in header, direct transmit of msgs
2011-02-13 15:49:24 +01:00
Harald Welte
2a0a9638d1
[RBS2000] Add initial code for Ericsson OM2000 O&M protocol
...
... and link it from the RBS2000 BTS support
2011-02-13 15:49:24 +01:00
Harald Welte
89e466e83d
[RBS2000] Add FIXMEs in code that is a crude hack
2011-02-13 15:49:24 +01:00
Harald Welte
f1e466a909
[RBS2000] Actually activate the RBS2000 support
...
The previous patch introduces new code for the RBS2000 but didn't
actually activate/call it yet.
After this patch, you can see LAPD being established and OM2000 messages
will fall into abis_nm.c (which of course has no clue about them).
2011-02-13 15:49:24 +01:00
Harald Welte
c2f27bab55
[RBS2000] Initial attempt at Ericsson RBS2000 support
2011-02-13 15:49:24 +01:00
Harald Welte
948098048a
[OML] Allow each BTS model to specify the OML callback
...
This allows us to add BTS models that do not use the standard TS 12.21 OML
2011-02-13 15:49:09 +01:00
Harald Welte
59c51e7156
DAHDI: print debug hexdump of every signalling msg we send
2011-02-13 15:47:26 +01:00
Harald Welte
0a47400700
[LAPD] Add minimal support for TE-side LAPD
2011-02-13 15:46:48 +01:00
Harald Welte
fccc25ca80
DAHDI: Register every FD in the select() exceptfd-set
...
This helps us to receive events even if we don't receive or transmit
anything on the line.
2011-02-13 15:46:08 +01:00
Harald Welte
a6ef1b215f
DAHDI: Handle exceptions
2011-02-13 15:44:53 +01:00
Harald Welte
81c51a8c53
E1 INPUT: Fix PCAP file generation for non-mISDN case
2011-02-13 15:44:22 +01:00
Harald Welte
18e489a0f9
E1 Input: Add new S_INP_LINE_INIT signal
...
This allows other code to listen ot a signal about a new line that
was just configured.
2011-02-11 16:49:41 +01:00
Harald Welte
4c826f7aba
[BSC] Move the BTS-type specific code from bcs_init.c to bts_*.c
...
bsc_init.c was a big mess even only for two supported BTS models,
so before adding more BTS types, this needs a cleanup.
All the BTS specific code from bsc_init.c has now moved into
bts_{siemens_bs11,ipaccess_nanobts}.c
This has required that input_event() and nm_state_event() get both
converted to proper libosmocore signals instead of referencing external
symbols.
2011-02-11 16:26:31 +01:00
Harald Welte
279d7529c5
[gb_proxy] vty: display the BVC BLOCKED status in 'show gbproxy'
2011-02-06 17:44:14 +01:00
Harald Welte
7b7eaa9b01
[gb_proxy] make sure bssgp cell id is copied correctly
...
When we copy a msgb, we need to make sure the msgb_cb->bssgp_cell_id
pointer points to data in the new message, not in the old message.
Thanks to Dieter Spaar for spotting this.
2011-02-06 17:17:05 +01:00
Harald Welte
41270723ee
[gb proxy] treat BVCI=1 consistently like signalling
...
1 is reserved for point-to-multipoint data, i.e. not a point-to-point BVCI.
2011-02-06 17:13:12 +01:00
Harald Welte
db2a2d534d
[gb_proxy] Convert a NS-BLOCK from BSS into BVC-RESET to SGSN
...
As we only have one NS-VC between gb_proxy and SGSN, we cannot
forward a NS-BLOCK from the BSS to the SGSN, as it would affect
all other BSS's, too.
Thus, we check if we have an unblocked PTP-BVC in the NSVC to the BSS,
and then issue a BVC-BLOCK towards the SGSN.
This should prevent any further PDU's from the SGSN to be sent to
this BSS.
2011-02-06 16:33:29 +01:00
Harald Welte
51b7d407f1
[gb_proxy] Track the state of blocked/unblocked BVC in the proxy
...
This allows us to reject any additional messages sent by the SGSN
after the BVC was blocked (+ acknowledged to be blocked)
2011-02-06 13:09:29 +01:00
Harald Welte
e08e9e5f74
remove dead code
2011-02-05 22:17:24 +01:00
Harald Welte
075b562f92
[DAHDI] cosmetic fixes
2011-02-05 20:26:27 +01:00
Harald Welte
cbaa38a948
[DAHDI] make sure LAPD transmits with correct SAPI
2011-02-05 20:26:27 +01:00
Harald Welte
32a743407e
[LAPD] fix bug in TEI manager rendering LAPD unusable
2011-02-05 20:26:27 +01:00
Harald Welte
c08f3b15b1
[DAHDI] remove unused variable
2011-02-05 20:26:27 +01:00
Harald Welte
306a2065ee
[LAPD] Support multiple instances of LAPD
...
We cannot afford static/global state, as we may have multiple E1
lines, each having its own LAPD instance. Furthermore, we might
even have multiple LAPD instances on the same E1 line (think of
a multi-drop setup).
This also implements dynamic TEI allocation, i.e. no hardcoded
TEI list anymore.
2011-02-05 20:26:27 +01:00
Harald Welte
a91e1c892d
[LAPD] remove a number of unneeded assert() calls
2011-02-05 20:26:27 +01:00
Harald Welte
9be5403e01
[LAPD] further code cleanup
2011-02-05 20:26:27 +01:00
Harald Welte
1b2494d2bf
[LAPD] use LOGP/DEBUGP instead of custom logging function
2011-02-05 20:26:26 +01:00
Harald Welte
348ffa8a9b
[DAHDI] update to latest e1_input changes
2011-02-05 20:26:26 +01:00
Harald Welte
c7841cc8a1
[DAHDI] build dahdi driver only if dahdi header is present
2011-02-05 20:26:26 +01:00
Harald Welte
890fe4a5ba
[DAHDI] integrate DAHDI driver into E1 Input layer
2011-02-05 20:26:26 +01:00
Harald Welte
6aef70dd41
[dahdi] remove lots of dead code and references to mISDN
2011-02-05 20:26:26 +01:00
Harald Welte
bdc1118450
[dahdi] don't export private functions from lapd.c
2011-02-05 20:26:26 +01:00
Harald Welte
6803ab2354
[dahdi] support multiple-include of lapd.h
2011-02-05 20:26:25 +01:00
Harald Welte
98d0103162
[dahdi] Fix LAPD code comments (C-style)
2011-02-05 20:26:25 +01:00
Harald Welte
8c911f8e95
[dahdi] Fix lapd.c coding style
2011-02-05 20:26:25 +01:00
creslin287
52b0e02c3d
Working audio data version
2011-02-05 20:26:25 +01:00
Matthew Fredrickson
eb3459e44b
Current LAPD with fixes for frames with P/F bit set
2011-02-05 20:26:25 +01:00