Activating / modifying to a VAMOS mode will require picking specific TSC
Set / TSC. It is a bad idea to pick the TSC in each message encoding
function, rather make this choice centrally.
So far we pick the training sequence code to use based on the timeslot
configuration, and this TSC is determined only upon encoding the RSL
messages.
Instead, pick the TSC to use upon the initial lchan activation /
modification request; store this in the request structs and pass through
the activation / modification code paths.
For VAMOS modes, we also need to pick a TSC Set. Do so also upon activ /
modif request. Note that the TSC Set is not yet applied in this patch,
it will be applied in upcoming VAMOS patches.
The activ / modif request may pass -1 for tsc_set and/or tsc to indicate
no specific choice of TSC Set and TSC, resulting in the same behavior as
before this patch.
For example, lchan->activate.info.tsc* may be passed as -1. The exact
choice for tsc_set and tsc is then stored in lchan->activate.tsc*, i.e.
one level up (the .info sub-struct is considered as immutable input
args). The lchan->activate.tsc* are the values actually encoded in RSL
messages. After the ACK, the lchan->activate.tsc* is stored in
lchan->tsc* to indicate the TSC actually in use. Same for modif.
Note that in 3GPP TS 45.002, the TSC Set are numbered 1 to 4, while the
TSC are numbered 0 to 7. On the wire, though, TSC Set is sent as 0 to 3
value. This is a weird discrepancy, odd choice made by the spec authors.
For conformance with the spec wording, I decided to pass the TSC Set
number as a 1-4 ranged value, and only convert it to the 0-3 on-the-wire
format upon message encoding. So log messages and VTY output will
indicate the first TSC Set as "1", but the first TSC as "0", as defined
in 3GPP TS 45.002, even if that is somewhat weird.
Related: SYS#5315 OS#4940
Change-Id: Ic665125255d7354f5499d10dda1dd866ab243d24
c33eb8d569