With recent addition of fake time in handover_test ('wait cmd'), show
how a penalty timeout in handover decision 2 passes and allows a
handover again after due time.
Related: SYS#5198
Change-Id: I65e59cc7309778cf9d71612669ce84d101c8135e
Use recently added fake-time 'wait' command to show how the lchan in
LCHAN_ST_WAIT_AFTER_ERROR recovers as soon as timer X3111 has passed.
This prepares for also waiting for the penalty timeout to pass.
Related: SYS#5198
Change-Id: I8f7668b6d08a0dac9e90d2358955f9d5099d39fa
In expect-ts-use, indicate a busy lchan with letter '!'.
The code is a bit complex because of the choice made earlier to show two
TCH/H subslots as "TCH/HH", "TCH/H-" or "TCH/-H" depending on the
subslot states:
- show "-" as a shorthand for "all subslots UNUSED"
- show a "TCH/" prefix only when there is any "H" or "F" following, i.e.
when any subslot is actually established
- if a subslot is busy (any other state besides ESTABLISHED and UNUSED),
indicate the subslot as '!'.
The spectrum of reported state strings for TCH/F is:
TCH/F ! -
For TCH/H:
TCH/HH TCH/H- TCH/-H TCH/H! TCH/!H !- -! -
The only current test affected is test_penalty_timer.ho_vty, where a
failed handover leaves an lchan in LCHAN_ST_WAIT_AFTER_ERROR. Adjust
that test.
Rationale: I will soon add tests to verify the accurate timeout of a
handover2 penalty timer. While implementing, I noticed that immediate
retry of the handover ends up in timeslot 2, because timeslot 1 is still
in WAIT_AFTER_ERROR. Instead of working around that, I would like to
explicitly show the error state in the test -- it is an important
aspect.
Related: SYS#5198
Change-Id: I735ce7e2c3e0e450d3f76047d7e47691fe889cad
The meaningful names expose that some of those tests are apparently
quite similar.
With names like this it is far easier to see whether a specific scenario
is already tested or not, and find a test when looking for a specific
scenario.
Change-Id: I6f6d65d818fd1265e8ff94a2e0afba6392c50eb9
Neels Hofmeyr